Control, operation

hbg max point

Enter the maximum permissible working height at the display. Position the attachment below the planned maximum working height.

Move the cursor to the hbg max point line and press the RIGHT button to change to the right field.

Press the UP or DOWN button to select the new value (in cm) and confirm with ENTER

The maximum working height (hbg max point) is staved. Move the cursor to the >back line and press the RIGHT button.

The display shows the subordinate menu.

*)Special equipment: The movement range of the stick can also be restricted when it is extended.

Checking stroke limitation

Turn key switch S249 to position 0 The stroke limitation function is activated. Prop up the machine, position the uppercarriage in longitudinal direction and lower the boom.

Using the boom cylinders, carefully move the attachment upwards to test the stroke limitation function.

When the maximum permissible working height is reached, the upward movement of the attachment must be stopped. If required, readjust the stroke limitation.

Y268 on/off (optional equipment)

Use this menu to activate the pedals for boom adjustment while an attachment (e.g. mower rake) is operated with the right joystick.

Menu navigation:

Use the UP and DOWN keys to select the "Y268 on/off" line.

Press the RIGHT key.

The cursor changes to the right section where you can change the parameter value.

Use the UP and DOWN key to select the desired setting.

1 = Use of pedals possible.

0 = Use of pedals not possible.

Press the ENTER button.

Move the cursor to the >back line and press the RIGHT button. The display shows the superordinate menu.

Stick limit (optional equipment)

This means that the stick can only be moved within a preset angle range (defined by a minimum and a maximum angle). The reach of the attachment thus depends on the stick cylinder shut-down point and the angle of the boom.

Danger!

Risk of injury and damage to equipment!

During the adjustment of stick cylinder shut-down, there is a risk that the attachment might collide with the operator's cab.

When adjusting the limitation function, operate the machine with extreme caution.

Settings in menus "stl max point" and "stl min point":

ValueStick position

0 (min)Stick fully extended

500Stick in centre position

1000 (max)Stick fully retracted