POWER OPERATED FRONT SEATS

Lumbar support adjustment* POWER OPERATED FRONT SEATS*

WARNING To avoid the risk of loss of control and personal injury, DO NOT adjust the driver's seat while the vehicle is in motion.

The seat adjustment controls are situated on the side of the centrally mounted cubby box. Seat adjustment is only possible when the starter switch is turned to position ‘II’ or for 45 seconds after opening the driver's door.

Forward/backward adjustment

H2622

Rotate the handwheel to increase or decrease support to the lumbar region of the back.

H2623

Push and hold the switch forwards or backwards to move the seat to the desired position.

Seat cushion angle adjustment Seat cushion height adjustment*

H2625

On some vehicles, the height of the seat cushion can be adjusted. Push the switch up or down to raise or lower the cushion.

H2624

Twist the switch to tilt the seat cushion to the desired position. Note that the front and rear of the switch work independently - the front raising or lowering the front of the cushion, the rear of the switch similarly controlling the rear of the seat cushion.

Lumbar support adjustment Seat back adjustment

H2626

Push the switch up to increase support to the lumbar region of the back. Lower the switch to reduce lumbar support.

H2627

Twist the switch forward or backward until the desired seat back angle is achieved.

WARNING DO NOT travel with the seat backs reclined steeply rearwards. Optimum benefit is obtained from the seat belt with the seat back angle set to approximately 25 degrees from the upright (vertical).