EVERY 500 SERVICE HOURS

Do all 50, 100 and 250 hour servicing at the same time.

BChanging Engine Oil(Change the engine oil every 500 hours,or every 1 year in the case that service hour is less than 500 hours)

(1) Filter (A) "AIR-CONDITIONER AIRFLOW"

(1) Air conditioner condenser (1) Drain plug

(1) Engine oil dipstick (2) Oil filling port (A) Required oil level range

A Pressure of compressed air must be under 205 kPa (2.1 kgf/ , 30 psi). A If the filter is very dirty, replace the air filter.

BChecking Air-Conditioner Condenser

Check air conditioner condenser to be sure it is clean from debris. To avoid personal injury: A First stop the engine then remove the key and wait long enough for the oil to cool down.

1.Remove the drain plug on the underside of the engine and drain all oil. 2.Re-tighten the drain plug.

3.Fill up with new oil through the filling port to the specified level.

4.Let the engine idle for approx. 5 min. Check the engine oil level. To check the engine oil level, insert the engine oil dipstick completely into the respective port opening and pull out again. If the oil level lies between both markings, no oil must be added.

A Regardless of the service hours, an engine oil change is due every 1 year. Engine oil volumes (with engine oil filter) 5.0 L (1.32 US gal)

BReplacing Engine Oil Filter Cartridge (Replace the engine oil filter cartridge every 500 hours,or every 1 year in the case that service hour is less than 500 hours)

1.Replace the oil filter cartridge at the same time as doing the engine oil change. 2.Remove the cartridge with the supplied filter wrench.

3.Oil the O-ring of the new oil filter cartridge lightly. Then tighten the oil filter cartridge by hand. 4.Fill engine oil to the specified level. 5.Let the engine run for approx. 5 min. and make sure that the engine oil indicator lamp does not light up.

Then stop the engine and remove the key. 6.The engine oil level is reduced by the amount of the filter capacity after the engine is started. It is usually necessary to add oil.

A Always check the oil level after having exchanged the filter. BDrive unit Oil Change(First Oil Change of the 50 hours)

To avoid personal injury: A Lower all attachments to the ground, stop the engine and remove the key before undertaking the oil change.

1.Rotate the track so that the drain plug of the drive unit is in the bottom position. 2.Remove the drain plug to let the oil run out. Screw in and tighten the drain plug again and fill with gear oil through the oil check port. 3.Fill oil until it overflows out of the oil check port.

Oil change - first oil change after 50 hrs - then every 500 hrs - or at least once a year

4.Use prescribed gear oil SAE 90.

(1) Oil filter cartridge

(1) Oil check port (2) Drain plug (3) Oil filling port

Gear oil volume approx. 0.65 L (0.17 US gal)