I. SAFETY/DECALS

These decals are not available from the Hagie 204SP Parts manual, but should be replaced if they are faded, damaged, or missing. They are placed there by our vendor. They are found on the right hand vertical post of the roll over protection device.

The top decal warns, “This structure’s protective capabilities may be impaired by structural damage, overturn, or alteration. If any of these conditions occur, the structure must be replaced. “.

The bottom decal warns of the use of the seatbelt.

Hagie Manufacturing urges you to obey all warnings found in this manual and on the decals placed on the machine and its components.

II. IDENTIFICATION NUMBERS

Detasseler Identification

Each Hagie detasseler is identified by means of a frame serial number. This serial number denotes the model, year in which it was built, and the number of the detasseler. For further identification, the engine has a serial number, the hydrostatic pump has a serial number, the wheel motors have identification tags, and the planetary hubs have identification plates that describe the type of mount and gear ratio. To ensure prompt, efficient service when ordering parts or requesting service repairs from Hagie Manufacturing Company, record the serial and identification numbers in the space provided below.

NOTE:

Reference to left-hand and right-hand used throughout this manual refers to the position when seated in the operator’s seat facing forward.

Detasseler

NOTE: Detasseler serial number stamped in the frame on right rear corner.

II. IDENTIFICATION NUMBERS

Left: Right:

Planetary Hubs w/Brakes

Left: Right:

Hydrostatic Pump

Front and Left Rear Wheel Motors

Front Left:

Front Right: Rear Left:

Right Rear Wheel Motor w/ sensor

Right:

Refer to parts manual.