1 minute read
IV. PREPARING TO OPERATE
Attaching Ls System
1. Install Tasseltrol ®/LS sensor arm weldment with the two nylon washers in the bottom hole in the tool bar (fig. 4.30, item 2).
2. Install the Tasseltrol®/LS cross tube weldment (fig. 4.30, item 3) to the sensor arm.
3. Install the left and right slide mount weldments (fig. 4.30, item 4) to the cross tube weldment.
4. Install the Tasseltrol®/LS reflector mount (fig. 4.30, item 5) and sensor mount (fig. 4.30, item 6) to the slide mount weldments.
5. Install the cable assembly according to the wire diagram in your HAGIE 204 Parts Manual.
6. With a tape measure, set the center of the top Tasseltrol® sensor to a depth of seven inches (fig. 4.31). Set the top edge of reflector to three inches (fig. 4.31).
7. Turn the ignition key switch to the “ON” position to check the sensor installation. DO NOT start the engine. See page 63. for more information about the LS sensor assembly.
