1 minute read
IV. PREPARING TO OPERATE
Attaching Cutter Heads
1. Attach the cutter head assembly to the tool bar (fig. 4.20).
NOTE:
Some cutters may come pre-assembled to the tool bar. In this case, you would attach the assembly to the lift assembly.
2. Install the stalk guides to the cutter head assembly (fig. 4.22, item 1)
3. Refer to pages 34-35 for information about installing hydraulic hoses.
Make sure the cutter blades operate in the correct dire ction (fig. 4.21).
4. Adjust the cutter heads using the adjusting bolts so the front of the cutter head is pointing downward approximately ½ inch (fig. 4.22).
