Additional pages

Change to the annual maintenance procedures (M 12)

This modified maintenance procedure describes how to change the filter cartridge for the vent filter.

On the GMK 4075, the hydraulic oil tank is on the left-hand side of the carrier behind the driver's cab. On all other crane types, the hydraulic oil tank is on the superstructure, behind the crane cab.

• Press down the bleed unit housing (3) and turn it to the left.

• Lift off the bleed unit housing.

• Replace the filter cartridge (4).

• Set down the bleed unit housing on the base plate (5).

• Press up the bleed unit housing and turn it as far as it will go to the right.

• Reset the contamination display (2). To do this, press in the pin (1) at the top of the bleed unit housing.

The coloured contamination display drops back into the contamination display.

Important note

Duplications of any kind and excerpts from this document are not subject to the revision service. Original documents of Deutsche GROVE GmbH are marked with the blue serial number of the truck crane on the cover sheet.

Duplications and printouts of data carriers on which Deutsche GROVE GmbH has delivered this document are also not subject to the revision service.

© Copyright reserved by Deutsche GROVE GmbH

Dissemination or duplication of this document as well as utilization and disclosure of its contents are prohibited unless expressly permitted. Infringement will incur liability for compensation. All rights pertaining to registration of patent or utility model are reserved.