1 minute read

Pump drive disassemble

4:31 Remove the 3 O ring seals from the Forward / High Clutch valve. 4:32 Remove the Cap screw and clamp plate and remove the 3rd Clutch solenoid valve cartridge.

4:33 Remove the 15 Bolts securing the Torque Converter housing to the front casing. 4:34 Using a suitable lever, prise the Torque converter housing away from the front casing.

4:35 Lift the housing from the front casing. 4:36 Using a suitable tool remove the seal from the Torque converter housing and discard.

4:37 Use Two flat bladed screwdrivers and remove the Thrust washer from converter housing. If the converter wear ring is worn drive out discard and replace.

4:39 Remove the 4 O ring seals from the oil transfer ports on the front casing.

4:41 Lift the Pump idler gear from the support shaft 4:38 The Front casing with Torque Converter housing removed

4:40 Remove the Spacer from the Pump idler gear

4:42 Remove the support shaft & Bearing assembly

This article is from: