1 minute read

OPERATING INSTRUCTIONS RH 30 F Operation

(Fig. 2-19:)

No.ElementFunctionSymbol

1Clock

2ThermometerPump transfer gearbox temperature Indicates the oil temperature in the pump transfer gearbox

3Pressure gaugeEngine oil pressure Indicates the oil pressure in the diesel engine lubricating system

4ThermometerDiesel engine temperature Indicates the temperature of the cooling liquid

5Warning lampPMS (PUMP MANAGING SYSTEM)

Lamp flashes: when the electrical system is on (engine stationary) in the event of a fault (engine running) short-circuit, cable break or defective componenent (magnetic pick-up, termperature probe for load-sensing or proportional valve)

Lamp is permanently lit when the programmed hydraulic oil temperature of 80°C is exceeded.

6Warning lampCELECT warning Lamp is lit up in the event of an HPI fault

The lamp moreover indicates the fault code. Contact Terex Germany after-sales service or engine manufacturer (see switch (52).

7Warning lampCELECT warning Lamp is lit up in the event of an HPI fault

The lamp moreover indicates the fault code. Shut off engine

Stop working.

Contact Terex Germany after-sales service or engine manufacturer (see switch (52).

8Warning lampCELECT warning Lamp is lit up (e. g.): when the engine oil pressure is too low when the cooling water temperature is too high

Shut off engine

This article is from: