OPERATING INSTRUCTIONS RH 200

Inspection and servicing

Battery Warning! Battery Posts, terminals and related accessories contain lead and lead compounds, chemicals known to cause cancer and reproductive harm. Wash hands after handling

Checking the battery fluid level

(Not applicable in case of maintenance-free batteries)

" Unscrew caps (Fig. 3-54:).

" If checking inserts are provided, the battery acid must reach up to their bottom.

" If no checking inserts are provided, insert a clean wooden rod into the battery until it contacts the upper edge of the cell plates. The rod must be moistened over at least 10 mm.

" If the fluid level is too low, top up with distilled water only

Removing and installing the battery

The acid temperature must be 20 ° C.

" Unscrew caps of the battery (Fig. 3-54:).

" Measure the acid density of the battery using a commercial acid tester (Fig. 3-54:). The acid density measured is in direct correlation with the battery charge.

Acid density

kg / dm3 Charge

Normal condition

Tropical conditions

1,281,23fully charged

1,201,12half charged, recharge 1,121,08discharged, recharge immediately