Upper rollers

the upperstructure and its attachments. Local national regulations stipulate the number , type and location reflector strips. • A void running the engine in a confined space. there is alternative, proper ventilation must provided all times. • not allow anyone else the machine. The passenger could fall cause accident. • Never operate the working travel controls unless you are properly seated in the operator ’s seat with the seat belt correctly fastened. • Before starting the engine, check the direction travel (in forward drive, the reduction gears should the rear the machine). • not work near overhead high - voltage electric lines without checking beforehand that all necessary measures have been taken respect the minimum distances:

Less than 57000 volts: 3 m ( 9.8 ).

More than 57000 volts: 5 m ( 16.4 ). • Study the position any existing pipelines conduits before starting work. Electrical cables, gas and water pipes and other underground installations can cause serious injury . • Always make allowance for working conditions (sloping rough ground), the site and weather conditions when driving the machine. • not allow anyone stand in the machine working area. Accidental operation the upperstructure swing control attachment control could cause accident. Stop all operations until everyone has moved away . • Operate all controls gradually ensure smooth machine operation. • Whenever load handling operations are carried out, it is imperative adhere strictly the instructions given in this manual and local legislation. • is forbidden use the machine carry out tasks other than those for which it is intended. Never use the equipment for sweeping the ground level out rubble push objects (transversal stress the attachment). • Stop the engine and remove the ignition key when the machine is not in use, even for short periods time. • The working area the end attachment that is mounted may interfere with the machine. Interference may caused due the type end attachment installation parts such a cab guard. Always maintain a safe margin distance. (Be careful tool swing accidental operations.) • To access exit the operator ’s compartment, the left hand control arm must in the raised position. Never forget this basic requirement. • Never leave the operator's compartment while the engine is running. • To get in out the cab, it is imperative that the upperstructure frame is in line with the undercarriage. • Dust, smoke mist can reduce visibility and cause accident. Reduce speed come a complete halt until visibility has improved. • Never jump down from the machine. When alighting from the machine the upperstructure, always face the machine and use the steps and access handles. • the event operating problem failure, move the machine a safe place, lower the attachment the ground, shut down the engine and remove the ignition key . Locate the problem, report it if necessary and take the necessary steps warn others not attempt operate the machine. • Before tilting the seat back forward, it is mandatory raise the armrests avoid any accidental operation the control levers. • (If equipped) certain positions the articulated boom, there can interference between the tool and the cab. Always maintain a safe minimum distance between the tool and the cab. • Never turn the key the battery master switch in “O” (Of position when engine is running, the electrical systems can damage (if equipped). • When the engine is stopped, always wait one minute minimum before place the key the battery master switch in “O” (Of position, otherwise the computer program the hydraulic will not exit successfully (if equipped).

Preventing risks caused vibrations

The machine's vibration fects the comfort and in some cases the health and safety the operator . To reduce vibration risks a minimum:

Make sure that the machine, the equipment and the tool are suitable for the work carried out.

Make sure that the machine is in good condition and that servicing intervals are complied with.

Check the track tension adjustment and the play in equipment linkages.

Make sure that the operator's seat and is adjustment controls are in good condition and then adjust the seat suit the operator's size and weight. The operator ’s seat complies with the ISO 7096 , 2000 standard, EM

6 class.

During work:

Operate all controls gradually ensure smooth machine operation.

Modify the machine's operation suit the working conditions.

During travel, adjust the machine's speed, reducing it if necessary .

Make sure that the machine's operating radius is in good condition, and free obstacles and holes.