FIRE OR EXPLOSION PREVENTION

• Engine fuel can cause an explosion or fire. Do not fill the fuel tank while the engine is running or if next to a flame, performing any type of welding work, smoking, etc. Use nonflammable cleaning solvent to clean parts. Sparks or flame can cause the hydrogen gas in a battery to explode. To prevent an explosion, do the following: 1. When disconnecting the battery cables, disconnect the negative (-) cable first; when connecting the battery cables, connect the negative (-) cable last. 2. When connecting jumper cables to start the engine, use the procedure as shown in “Booster Battery

Connection” on section “Operating Instructions”. 3. Do not short circuit the battery posts with metal items. 4. Do not weld, grind, or smoke near a battery. Keep open flame away from the battery.

•

Sparks from the electrical system or engine exhaust can cause an explosion or fire. Before you operate this machine in an area with flammable dust or vapors, use good ventilation to remove the flammable dust or vapors. • DO NOT smoke while refueling the machine. • Its not recommended to operate the machine in places where combustible organic material exists or in public areas, using a natural aspiration engine or functioning by methane gas, unless an appropriate optional muffler for sparkles detention is used.

• A fire can cause injury or death. Always have a fire extinguisher near or on the machine. Make sure the fire extinguisher is serviced according to the manufacturer’s instructions. If a fire extinguisher has been used, always recharge or replace the fire extinguisher before operating the machine. Remove all trash or debris from the machine as required. Make sure you do not store oily rags or other flammable materials on the machine. If the machine has an oil, fuel, or hydraulic leak, always repair the leak and clean the area before operating. Keep the cooling system clean and maintain the correct coolant level. Starting fluid (ether) can explode and cause injury or death. Do not breathe starting fluid vapors. Wear face protection when you remove or install a starting fluid container or when you use an aerosol spray starting fluid. Use starting fluid according to the instructions in this manual. Keep the starting fluid (ether) reservoir out of children’s reach. Before discarding an empty starting fluid reservoir, use rubber gloves, and press in the valve located at the end of the reservoir, in order to relief the remaining pressure. Do not drill holes and neither throw the reservoir in flames. Do not store a starting fluid (ether) reservoir in areas reserved for the operator on the machine. If you weld, grind, or use a cutting torch on the machine, always remove the starting fluid container from the machine. Use compressed air to remove any ether fumes from the area. Before welding on this machine, disconnect the battery ground (-). Check the electrical system for loose connections or frayed insulation. Repair or replace the loose or damaged parts.