Error codes

A

E D C B

When an error occurs a code is displayed in character window (A) and the indicator window (E) lights. The effect of each error code on the truck is shown in the table below.

E101 Hardware error The truck cannot be started

E104 Hardware error The truck is stopped E106 Too high current on digital output or field current too high The truck is stopped E107 Main contactor not turned on The truck is stopped E108 Contactor welded The truck is stopped E110 System error The truck is stopped E140 Check sum error The truck is stopped E141 Faulty software The truck is stopped E150 Communication fault The truck is stopped E151 Communication fault The truck is stopped E157 CAN-bus fault The truck is stopped E159 CAN-bus fault The truck is stopped E160 Faulty safety reversing function The truck is stopped E200 Shunt winding open The truck is stopped E201 Faulty M-minus, transistor unit The truck is stopped E202 Faulty current shunt in transistor unit The truck is stopped E214 CAN time-out, transistor unit The truck is stopped

The truck can be equipped with different accessories to supplement its functions or to further increase your safety when using the truck. Accessories can be combined.

The truck can be equipped with a folding platform, the platform automatically folds up when not loaded.

The load support increases the stability of the load when handling high loads.

The charger starts automatically when its plug (B) is connected to a wall socket. The orange LED (A) comes on. At the same time all the truck’s electric functions are cut-out so that the truck cannot be used during the period the charger is connected. The green LED comes on when charging is completed. A red LED flashes if a fault should occur with the charger. A steady red light indicates that the switch for setting the battery type is in an inactive position. Before using, the integrated charger must always be set (see pos. C) according to battery type/size that is installed in the truck. See the information plate on the charger for further information on settings. Once charging is completed the plug replaced in its holder in order for the truck to be operational again. For further information on charging refer to the chapter .

The truck can be equipped with a turtle button as an option. Pressing the button (SLOW is shown on the display) enables a temporary speed reduction. The speed is controlled by means of parameter 1. Pressing the button once again returns the speed to the set default value.