Skip to main content

Los Olivos K2 | Quality Specifications · Oliva Nova

Page 1

k2

SPECIFICATIONS


MEMORIA SPECIFICATIONS DE CALIDADES

STRUCTURAL SYSTEM

ROOFS

Shallow foundation based on reinforced concrete slab or wall footing, according to structural calculation and terrain characteristics.

Non-passable roofs with inverted system with: slope formation based on lightened mortar; waterproofing of modified bitumen sheet armed with polyester fiber, mortar regularization layer; thermal insulation of extruded polystyrene sheets of high thermal performance, geotextile separator layer; finishing layer with washed gravel of 30 mm leveled.

Reinforced concrete sanitary slabs supported on concrete block factory load-bearing walls, plastered with cement mortar externally and covered with drainage sheet that separates it from the ground. Structure of reinforced concrete gantries in accordance with building regulations.

FACADES Double-sheet enclosure: outer sheet of 15 cm blocks type Termoarcilla air chamber separating the inner sheet; and a self-supporting interior panel with 15mm plasterboard on 70-mm galvanized profiles and mineral wool-based insulation. Insulation thicknesses based on energy calculations until the façade is optimized to obtain an A or B energy rating. Exterior cladding on facades: Double rendering on a base with priming mortar and finished with water-repellent mortar sprayed and reinforced with plasticized fiberglass mesh in the areas where different materials meet, finished with waterproof paint.

Insulation thicknesses depending on energy calculations to optimize the roof to obtain an A or B energy rating. On walkable roofs, the gravel finishing layer is replaced by exterior floor covering.

Entrance door with reinforced protection with five locking points, of reinforced galvanized steel interior structure, PVC coated in the same color as the carpentry.

COMPARTMENTALIZATION SYSTEM Interior partitions using laminated gypsum board with sound insulation on the inside. Finishing by smooth plastic paint, with two coats, in a colour to be chosen.

INTERIOR CARPENTRY ELEMENTS EXTERIOR CARPENTRY Carpentry of aluminium with thermal break. Tilt/turn or slide opening system according to plans. Lacquered in colour medium grey RAL 7046 MATT. Motorised extruded aluminum roller blinds are in the same color as the carpentry in bedrooms and in the rest of rooms will be installed in those gaps where it is required according to energy demand study. Double glazing with laminated glass according to regulations and thermal performance according to energy calculations required by the Technical Building Code.

Hinged or sliding interior doors with dimensions according to the plan, made of water-repellent DM chipboard and white lacquered finish RAL 9003. Built-in kit wardrobes, melamine board interiors with imitation textile finish with shelves and upper compartmentation; hanging fittings and sliding or folding doors according to plan, smooth with white lacquered finish. Progressive closing system.

FLOOR AND WALL COVERINGS Floors inside: rectified porcelain stoneware flooring BELLACASA – Lucena Perla 60x60 or equivalent, taken with special high-adherence glue, on a selfleveling mortar base. In the nighttime areas and


MEMORIA SPECIFICATIONS DE CALIDADES

interior stairwells, SPC vinyl flooring with an Oporto Oak wood-grain finish or similar will be installed over self-leveling mortar. Floors on outdoor terraces: The same model with anti-slip finish will be installed. In bathrooms, BELLACASA porcelain tile (Lucena Perla 30x90 model or equivalent), installed horizontally, and white, washable enamel paint. In dry areas and the rest of the apartment, finish with two coats of smooth white plastic paint, on the previously prepared support. False interior smooth plasterboard ceilings, with curtain pelmets in the façade openings. Finished with three coats of white matt plastic paint. Where necessary in bathroom ceilings, revision openings will be installed to control the installations.

PLUMBING INSTALLATION Cold water installation, which includes: Indoor cold water network based on uprights and branches from general internal stopcock to consumption and supply points, using Cross-linked Polyethylene (PEX) piping. Domestic hot water production system using an electric storage tank with photovoltaic backup to maintain the energy efficiency rating. Indoor hot water network, based on uprights and

branches from the aerotherm to consumption and supply points, by channeling multilayer cross-linked polyethylene pipes with aluminum core (PEX-AL-PEX).

ENVIRONMENTAL THERMAL CONDITIONING INSTALLATION Installation of ducted air conditioning and grills with air-liquid refrigerant heat pump, inverter, for cooling and heating.

• Indoor distribution network, in Low Voltage, with high electrification, indoor and outdoor distribution circuits. • Decorative control mechanisms and bases type Simón 82 Detail or equivalent in white. • Ground-to-ground protection network, based on independent protection network, buried ground network and equipotential protection networks in bathrooms. • High degree of electrification of the apartment, according to specific indications of the Low Voltage Electrotechnical Regulation.

INDOOR AIR QUALITY AND TREATMENT INSTALLATION

• Circuits dimensioned for a single-phase power of 9.2 kW.

Installation of controlled mechanical extraction (VMC) based on mechanical-controlled centralized extraction system, for indoor air extraction ventilation, formed by in-line extractors type Siber or equivalent.

• Channeling for TV and telephony. RJ45 sockets in all rooms (not including toilet and bathrooms). • Photovoltaic installation for self-consumption. • Installation of DTT antenna. • Electronic intercom.

ELECTRIFICATION INSTALLATION Indoor electrical installation in Low Voltage, which includes:

ALARM INSTALLATION

• Connection facilities and general power supply line with the street electrical network and general protection box.

Installation of a multi-zone alarm system by infrared detectors inside the apartment, central unit with microprocessor for control and alarm.


MEMORIA SPECIFICATIONS DE CALIDADES

BATHROOMS

EQUIPMENT SYSTEM IN KITCHEN

Sanitary objects:

Furniture and fixed elements

ROCA THE GAP SQUARE wall-hung toilets with concealed cisterns.

Fitted kitchen with units with laminate fronts in natural oak finish. Porcelain worktop and wall covering 12 mm Xcelanic Torano Oro.

In master bathroom cabinet from CODIS with washbasin integrated countertop CRISTALPLANT from CODIS. In the toilet, bathroom cabinet by CODIS with a ROCA THE GAP ROUND model porcelain countertop washbasin. In secondary bathroom, bathroom cabinet by CODIS with an integrated washbasin and CRISTALPLANT worktop by CODIS Prefabricated flat shower pans made of NESVIT resin and mineral fillers, with a white finish and dimensions customized to fit each bathroom, fully flush with the floor. Taps and fittings: In bathrooms the taps are of the ROCA brand, L20 chrome finish model. In kitchen mixer tap of the make ROCA brand, L20 chrome finish model. Single-panel folding glass shower enclosure. Chrome finish.

Household Appliances BALAY stainless steel oven, 60 x 60 cm. Induction hob BALAY, with built-in extractor, 70 cm frameless or similar.

NOTES: Once the structure of each floor of the building is completed, no changes can be made to the interior of the apartments. All finishing materials must be selected by that time, otherwise they will be selected by Construcciones Hispano Germanas, S.A.U. and cannot be changed later. Construcciones Hispano Germanas, S.A.U. reserves the right to make changes for technical, commercial, supply, etc. reasons, provided that these do not mean any decrease in quality. This document has no contractual validity and is only valid for informational purposes.

The materials, elements, procedures and specifications described in this document are indicative and subject to modification by technical requirements of the Optional Management of the construction works and the regulations in force, guaranteeing in any case the maintenance of the general level of quality of the building and the apartments. Construcciones Hispano Germanas S.A.U is the owner of the images and infographics, which are not contractually binding and are merely informative and for guidance purposes.


PROMOTES

IN THE UNIQUE ENVIRONMENT

10.2026


Turn static files into dynamic content formats.

Create a flipbook
Los Olivos K2 | Quality Specifications · Oliva Nova by grupo.chg - Issuu