1 minute read
REAR AXLE (for F2100E)
The rear axle of the 2WD type is constructed as shown above.
The knuckle shaft (king pin (8)) is attached to the rear axle (4) by the ”RUMOAN“ method rel ativel y simple, and the rear axle is supported at its center with center pin (3), so that steering operation is stable even on an uneven ground
Advertisement
[2] STARTING SYSTEM
Atthe"PREHEAT" Position
When the main switch is turned to the "PREHEAT" position, terminal B is Connected to terminals M and G. The glow plug becomes hot.
When the main switch is turned to the "START" position, terminal B is connected to terminals M and G and ST. Electric current flows to the controller from terminal ST. Under the following condition, a start signal flows to the starter and starts the engine.
Starting Condition e SaIety switchis"ON"
• PTO switch is "OFF"
