SKATE BENCH ASSEMBLY INSTRUCTIONS
MIN. 2 PEOPLE REQUIRED FOR STEPS 1 & 4
FRONT BACK PANEL
STEP 2 –REACH THROUGH HOLE AND SCREW 2 SECTIONS OF BENCH TOGETHER
STEP 3–REACH THROUGH HOLE AND SCREW “BASE” TO “BENCH”
BASE STEP
STEP 1 –WHILE UPSIDE DOWN, SCREW THROUGH THE INSIDE TO SECURE BOTH PIECES TOGETHER
STEP 1 –2 PEOPLE REQUIRED FOR THIS STEP: PLACE LARGE CARDBOARD OR BLANKET ON GROUND. TIP BOTH “BASE STEP” PIECES UPSIDE DOWN ON CARDBOARD/BLANKET. SCREW THROUGH THE INSIDE TO SECURE BOTH PIECES TOGETHER AT THE CENTRE OF THE “BASE STEP”.
STEP 2 –REMOVE DRAWERS. REACH THROUGH HOLES IN BENCH SEAT AND SCREW 2 SECTIONS OF “BENCH” TOGETHER.
STEP 3 ‐ WITH DRAWERS STILL REMOVED, SET CUSHIONS ON “BENCH” SEAT AND SECURE IN PLACE BY REACHING THROUGH DRAWER OPENINGS AND SCREW IN FROM BELOW. USE 1‐1/4” WASHER HEAD SCREWS. DO NOT USE LONGER SCREWS AS THEY WILL POKE THROUGH THE WOOD.
STEP 4 ‐ 2 PEOPLE REQUIRED FOR THIS STEP: TIP “BASE STEP” UP‐SIDE RIGHT AND PUSH TIGHT AGAINST FRONT EDGE OF “BENCH”. PULL OPEN DRAWERS AND REACH THROUGH HOLES IN “BENCH” SEAT TO SCREW “BASE STEP” TO “BENCH”
STEP 5 –INSTALL ACCESSORIES ON THE BACK OF THE BENCH (IF APPLICABLE)