2
1
3 Foil Drive M5 Split Bolt
Cable O-Ring
PREPARE MOTOR
verify Cable o-rinG
Apply a thin layer of Foil Drive Grease around the outside of the plug, NOT inside the plug.
Check the Red O-Ring is installed on the puck
6
4x M4 Bolts
GENTLY REMOVE PUCK
Pull the puck out of the mast, being careful not to pull tight on the cables.
verify Cable o-rinG
Apply a thin layer of Foil Drive Grease around the outside of the plug, NOT inside the plug.
Check the Red O-Ring is installed on the puck
9
GENTLY REMOVE PUCK
Pull the puck out of the mast, being careful not to pull tight on the cables.
Fold Cables
bolt puck to motor
insert puck & Motor back into the mast
Ensure the cables are in between the gap of the puck
8
7
3x M4 Bolts
tighten the split bolt
6
4x M4 Bolts
Ensure the cables are in between the gap of the puck
REMOVE THE SPLIT BOLT
5
4
insert puck & Motor back into the mast
8
7
Foil Drive M5 Split Bolt
PREPARE MOTOR
Fold Cables
bolt puck to motor
3
Cable O-Ring
REMOVE THE SPLIT BOLT
5
4
2
1
9
3x M4 Bolts
fit cable to electronics box
secure mast to electronics box
Blue O-Ring MUST be clean, well lubricated & in place. Use Foil Drive Grease to lubricate O-Ring if needed, then plug in the cable and install the bolts.
secure mast to electronics box
you must read this instructions card and
the user manual before assembly or use.
the user manual before assembly or use.
install and use this product only as
install and use this product only as
instructed for the intended purpose. after every use.
fit cable to electronics box
Blue O-Ring MUST be clean, well lubricated & in place. Use Foil Drive Grease to lubricate O-Ring if needed, then plug in the cable and install the bolts.
you must read this instructions card and
remove rotor, wash,dry & LUBRICATE
tighten the split bolt
instructed for the intended purpose.
FOR INSTALLATION SCAN QR CODE
remove rotor, wash,dry & LUBRICATE after every use.
FOR INSTALLATION SCAN QR CODE