0 1
TIPS TO MAINTAIN YOUR TYRES IN GOOD CONDITION aawestautomotive.com.au
0 2
INSPECTION To prevent your tyres from failing early, you must do a proper visual inspection. Make sure the surface and sidewall of the tyre for any irregularities like bulges, cuts, and cracks and remember to check the inner surface too. Cracks due to stones, glass, or other debris on the road may worsen over time, failing tyres. You have a check with rims too, as a damaged one may also lead to tyres failure over some time and should be replaced as soon as possible. If you found a nail embedded in your tubeless tyres, but the pressure is usual, do not pull it out as this may cause the air to escape. You have to repair it at the earliest.
0 3
MAINTAIN ACCURATE TYRES PRESSURE
The most significant aspect of maintaining car tyres in Windsor is checking the correct tyres pressure. Your owner's manual will help you with the correct pressure for your tyres. Tyres lose air pressure after nonstop driving and are desired to be refilled every month. Have a check with the pressure on a fortnightly basis on all the four tyres in your vehicle. The best time to do so is when the air conditioner is cold in the morning. You can also decide to fill your tyres with nitrogen, which desires to be checked only once in two months.
0 4
TRACKTHETYRES ROTATION SPECIFIED BY THE MANUFACTURER
Tyres rotation is significant for reducing uneven tyre wear. One should always go after the tyres rotation specified by the manufacturer. This helps in even the wear and tear of your tyres and increases their lifespan. The tyres need to be rotated because the front tyres apply more pressure than the rear ones. Every wheel present in your car has uneven wear characteristics that make rotation an essential process.
Service
Team
Contact
Aligning the wheel has more work to do with the suspension, which affects the car's tyres. A car's arrangement gets uneven overtime after driving on rough roads, tarmac, potholes and some others. Aligning the wheel readjusts the parts and permits the tyres to roll parallel and stay perpendicular to the land. In the case of wheel balancing, the tyres lose their weight and are not level from the side, resulting in uneven wear and tear. However, counting small amounts of weight can correct this issue and ensure a longer life for your tyres.
0 5
GETWHEEL ALIGNMENT AND BALANCING DONE
About
About
Service
Team
Contact
EXAMINE TREAD WEAR Tyres have a tread-wear indicator marked by a small arrow on the external wall of the tyres. If you go after the arrow on the tread face, you may notice the wear indicator on the surface of the tyres. If the external layer of the tyres touches the tread wear indicator, it is time for a replacement. Any tyres with less than 2mm of depth left may be replaced as soon as possible.
0 6
SIZE OFTHEWHEEL BOLTS
Usually, the wheel bolts are supplied by the vehicle manufacturer. They assure you that the bolts used are not too short or long. If they are short, there is a probability of the wheel popping out, or else, if they are too long, they may injure the car's suspension. In both of these cases, they can turn foes. Examine them and get them replaced with the perfect size ones.
0 9
office@aawestautomotive.com.au
(02) 4577 5600
CONTACT US
Disclaimer: This is a generic Information & post; content about the services can be changed from time to time as per your requirements and contract. To get the latest and updated information, contact us today or visit our website.