4194HA~HB~HC Controller Instruction Manual

Page 3

4194HA, HB, and HC Series Section 1 Introduction

configurations are indicated by letter suffixes in the type number that correspond to the mode and option designated in table 1-1.

Scope of Manual

The specific controller type number (with letter suffixes) is located on the nameplate (figure 1-1). Refer to table 1-1 for the definition of each 4194H Series Controller type number.

This instruction manual provides installation, operating, calibration, maintenance, and parts ordering information for the 4194HA, HB, and HC Series (high static pressure) differential pressure indicating controllers. Portions of this manual apply only to specific 4194HA, HB, and HC Series controller configurations. These

Only personnel qualified through training or experience should install, operate, and maintain this controller. If there are any questions concerning these instructions, contact your Fisher Controls sales representative or sales office before proceeding.

NAMEPLATE

W5907/IL

W5908*/IL

Figure 1-1. 4194H Series Differential Pressure Controller

Table 1-1. Available Configurations TYPE NUMBER(1) 4194HA Series

4194HA 4194HAE 4194HAM 4194HAME

4194HB Series

4194HB 4194HBE 4194HBF 4194HBFE 4194HBM 4194HBME 4194HBFM 4194HBFME

4194HC Series

MODES Proportional-Only

Proportional-PlusReset

OPTIONS Proportional-PlusReset-Plus-Rate

Anti-Reset Windup

X X X X

Remote Set Point

Internal Auto/ Manual Station X

X X X X X X X X X X

4194HC 4194HCE 4194HCF 4194HCFE 4194HCM 4194HCME 4194HCFM 4194HCFME

X X

X X

X X X X X X X X X X

X X X X X

X X X

X X

X X

X X X X X

X X

1. Reverse-acting constructions are designated by an R added to the type number.

1–1


Turn static files into dynamic content formats.

Create a flipbook
Issuu converts static files into: digital portfolios, online yearbooks, online catalogs, digital photo albums and more. Sign up and create your flipbook.