PaintExpo Expo LACQUER TESTING
Fraunhofer-Institut für Fertigungstechnik und Angewandte Materialforschung IFAM
PolyShear – the Miniature Test Loop of the Fraunhofer IFAM This laboratory unit for paints and coatings was specially developed for paint/lacquer manufacturers and users. PolyShear subjects the paint/ lacquer to shear following a test protocol. The system only requires a liter of material. PolyShear simulates the
shear stress on a paint/ lacquer on a laboratory scale and provides key information about whether the material meets specific paint/lacquer requirements. ¾ Rapid information about the shear and storage stability of paints/lacquers
MASKING
HangOn GmbH
HangOn – Smart Solutions for Masking Tasks As one of the new SmartProducts11 HangOn will showcase test panels with protective film KOP. These new “knock out” test panels minimize paint build up on the panel edge due to the sacrificial frames. No hanging marks are produced
due to the 4.0mm holes in the frames which allow vertical or horizontal hanging. The test panels have a protective PE film on the prepared side (which is recognized by the large radius top right corner on each panel) to protect from scratches, corrosion and
¾ Laboratory scale unit, hence low space requirements ¾ Minimal material usage and environmentally friendly: small quantities of paint/lacquer, short cycle and rinsing times ¾ Very good reproducibility of actual processes in large loops
Fraunhofer-Institut für Fertigungstechnik und Angewandte Materialforschung IFAM, Lacktechnik, Wiener Strasse 12, 28359 Bremen, Germany, Phone +49 421 22460, info@ifam.fraunhofer.de, www.ifam.fraunhofer.de Hall 2, Stand 2229 (IKON booth)
finger prints. The film is easily removed when the product is suspended. These panels are suitable for Qualicoat, GSB, QIB and ISO Standards.
HangOn GmbH, Erlenstrasse 12, 71297 Moensheim, Germany, Phone +49 7044 9006889, verkauf@hangon.de, www.hangon.de Hall 2, Stand 2211
PAINT LOGISTICS
JESSBERGER GmbH
Mixing Pump Tube – ATEX Certified and Safe to Run Dry JESSBERGER will showcase a mixing pump tube made of Stainless Steel 1.4571 at PaintExpo. It is suitable to run dry and ATEX certified. This pump tube is used for the mixing of clean, thin-fluid, lightly viscous, aggressive and non-
aggressive, inflammable and non-inflammable liquids in drums (1000 mm) or containers (1200 mm) and for pumping these media out of such drums/ containers.
JESSBERGER GmbH, Jaegerweg 5, 85521 Ottobrunn, Germany, Phone +49 89 666633400, info@jesspumpen.de, www.jesspumpen.de Hall 1, Stand 1401
international PAINT&COATING magazine - MARCH/marzo 2012 - N. 14
93