Adjustments

Bed Storage Floor Chains

It is important to keep this machine adjusted correctly to get the best performance out of this machine and to reduce wear and tear on components resulting in less down time and broken components. Follow the short instruction below to correctly adjust the bed floor storage chain assemblies.

• Check to see if the chains need to be adjusted • Tighten up Nut 1 whilst holding Nut 2 with a 24mm ring spanner until the floor slats are just sitting on the rear chain guides or contacting the chain guide 20 mm down on the front side (see drawing). Adjust Nut 1 at small intervals.

ADJUSTMENT CONT.

Elevator Chains

It is important to keep this machine adjusted correctly to get the best performance out of this machine and to reduce wear and tear on components resulting in less down time and broken components. Follow the short instruction below to correctly adjust the bed floor storage chain assemblies. • Check to see if the chains need to be adjusted • Loosen off the bolts that clamp the elevator shaft cover to the elevator screen • Loosen off the large Nut 1 locking nut • Tighten up the large Nut 2 until the elevator slats are just sitting in-between the arrows on the end elevator end plates. Note that the elevator chain needs to be able to swing 30mm each way (see drawing). Adjust Nut 2 at small intervals and adjust both nuts at the same time to get an even chain tension on both sides. • Tighten up large Nut 1 to lock up the shaft bush holders. • Recheck elevator tension is still correct • Re-clamp elevator shaft so there is a minimum 5mm gap between the elevator slat and the elevator shaft cover.

Refer to drawings on next page for part locations DO NOT OVER TENSION THE ELEVATOR CHAINS.

ADJUSTMENT CONT.

ADJUSTMENT OF THE X-FLOOR CHAINS

It is important to keep this machine adjusted correctly to get the best performance out of this machine and to reduce wear and tear on components resulting in less down time and broken components. Follow the short instruction below to correctly adjust the bed floor storage chain assemblies.

• Check to see if the chains need to be adjusted. • Loosen off the large Nut 1 locking nut. • Tighten up the large Nut 2 until the XFloor slats are just sitting on the lower panel returns (see drawing). Adjust Nut 2 at small intervals and adjust both nuts at the same time to get an even chain tension on both sides. • Tighten up large Nut 1 to lock up the shaft idler shaft assembly. • Recheck chain tension is still correct. • Adjust the middle shaft holder so that there is minimal pressure on the shaft in the outward direction

Slat Just Touching

Nut 2 Nut 1