EN07–14
FUEL SYSTEM (E13C)
IMPORTANT POINTS - MOUNTING 1. (1) (2) (3)
INSTALL THE COMMON RAIL ASSEMBLY. Install the O-rings to the injection pipe installation part of common rail. Install the common rail on the cylinder head and tighten the 4 bolts. Apply liquid gasket (ThreeBond TB1207B or equivalent) to the pressure sensor oil seal, then install the oil seal to the cylinder head. Tightening Torque: 25 N⋅m {255 kgf⋅cm, 18 lbf⋅ft}
NOTICE Wipe out excess liquid gasket completely.
SHTS011100700029
2. (1) A
(2)
INSTALL THE INJECTION PIPE AND LEAKAGE PIPE. Install the injection pipe (A) and tighten the pipe nuts to the specified torque. Install the injection pipe (B) and tighten the pipe nuts to the specified torque.
B SHTS011100700030
(3)
D
C SHTS011100700031
Install the leakage pipe and tighten the union bolt to the specified torque. Union bolt (C): M10x1.5 (Cylinder head side) Union bolt (D): M10x1.0 (Injector side)
NOTICE
•
If the tightening torque of the nuts is less than the specified value, it may cause a fuel leak. If the tightening torque of the nuts is greater than the specified value it may have a negative influence on the engine function. As a result, always perform torque management.
•
After the operation is] completed, wipe off the fuel which leaked and start the engine. Make sure that the fuel does not leak again.