Safety Data

LUBRIPLATE® 130-AA

Manufactured by:

Fiske Brothers Refining Co. Phone: (419) 691-2491

First Aid:

SKIN: Remove any contaminated clothing and wash with soap and warm water. If injected by high pressure under skin, regardless of the appearance of its size, contact a physician IMMEDIATELY. Delay may cause loss of affected part of body.

INGESTION: Call a physician immediately. Do not induce vomiting.

EYES: Flush with clear water for 15 minutes or until irritation subsides. If irritation persists, consult a physician.

Fire:

FLASH POINT: COC- 400 F Cool exposed containers with water. Use foam, dry chemical, carbon dioxide or water spray.

Environment:

WASTE DISPOSAL: Assure conformity with applicable disposal regulations. Dispose of absorbed material at an approved waste disposal facility or site.

SPILLAGE: Scrape up grease, wash remainder with suitable petroleum solvent or add absorbent.

Handling/ Storage:

Keep containers closed when not in use. Do not handle or store near heat, sparks, flame or strong oxidants.

JAW LUBE (P/N: PRG510-130)

Distributed By:

Emhart Teknologies Phone: (203) 924-9341

First Aid:

SKIN: Wash with soap and water until no odor remains. If redness or swelling develops, obtain medical assistance. Wash cloths before reuse.

INGESTION: Do not induce vomiting! Do not give liquids! Obtain emergency medical attention. Small amounts that accidentally enter mouth should be rinsed out until taste of it is gone.

EYES: Flush with water.

Fire:

FLASH POINT: Greater than 200 F Can be made to burn. Use water spray, regular foam, dry chemical or carbon dioxide.

Environment:

WASTE DISPOSAL: Do not flush to drain or storm sewer. Contract authorized disposal service.

SPILLAGE: Contain Spill. Absorb onto inert material. Shovel, sweep or vacuum spill.

Handling/ Storage:

NFPA Class IIIB Storage. Avoid prolonged breathing of mist or vapor. Avoid prolonged or repeated contact with skin. Avoid contact with eyes. Wash thoroughly after handling.

Please refer to the actual MSDS for complete safety and handling information. These can be obtained from the point of purchase.

MOBIL DTE 26 (P/N: PRG540-130)

Distributed By:

Emhart Teknologies Phone: (203) 924-9341

Manufactured By:

ExxonMobil Corporation Emergency Phone: (609) 737-4411 MSDS Fax on Demand: (613) 228-1467 MSDS # 602649-00

First Aid:

SKIN: Remove contaminated clothing and shoes and wipe excess from skin. Flush skin with water, then wash with soap and water. If irritation occurs, get medical attention. Do not reuse clothing until cleaned.

INGESTION: Do not induce vomiting. In general, no treatment is necessary unless large quantities of product are ingested. However, get medical attention.

EYES: Flush with water. If irritation occurs, get medical attention.

Fire:

FLASH POINT: 390 F/198.9 C Material will float and can be reignited on the surface of water. Use water fog, ‘alcohol foam’, dry chemical or carbon dioxide (CO2) to extinguish flames. Do not use a direct stream of water.

Environment:

WASTE DISPOSAL: SPILLAGE: Soak up residue with an absorbent such as clay, sand or other suitable material. Place in a non-leaking container and seal tightly for proper disposal.

Handling:

Wash with soap and water before eating, drinking, smoking, applying cosmetics or using toilet. Properly dispose of leather articles such as shoes or belts that cannot be decontaminated. Use in a well ventilated area.

Storage:

Store in a cool, dry place with adequate ventilation. Keep away from open flames and high temperatures.