BURNER ORIFICE FIGURE 14
BLOWER (S) REMOVAL
1. Refer to FIGURE 14. Disconnect power to fireplace and blowers. 2. Remove door assembly, logs and coals. 3. Disconnect gas supply piping/ tubing from gas valve. 4. Disconnect electrical connections at the Snapdisc thermostat by carefully pulling off wires connected to the Snapdisc thermostat. 5. Disconnect wiring connection between gas valve and ON/OFF switch or thermostat wire. 6. Remove 2 sheet metal screws that hold down the burner tube weldment; and remove burner. 7. Remove all sheet metal screws from Removable Burner Pan. Remove entire Burner Pan carefully and set aside. 8. Remove two Thumb Screws that secure the blower assembly to the unit floor. Blower assembly can now be removed through the rectangular access hole. Once blowers have been replaced or serviced, reassemble in reverse order. NOTE: Seal access plate with stove cement or 600ยบF RTV sealant before assembling in place.
3 0