OBJ_BUCH-1407-001.book Page 26 Monday, January 17, 2011 2:58 PM
26 | English
Assembly
Technical Data Drive Unit
Drive Unit
Article number Rated continuous output
0 275 007 000/ 0 275 007 001 W
250
Nm
50
Rated voltage
V=
36
Operating temperature
°C
–5...+40
Storage temperature
°C
Output torque, max.
Weight, approx.
–10...+50 IP 5K4K (protected against dust and splash water)
Degree of protection
kg
Drive HMI
4 HMI
Article number
1 270 020 900
Operating temperature
°C
–5...+40
Storage temperature
°C
–10...+50 IP 5K4K (protected against dust and splash water)
Degree of protection
kg
0.15
Rated voltage
V=
6
Power output – Front light – Rear light
W W
2.4 0.6
Weight, approx. Lighting*
Inserting and Removing the Battery For inserting and removing the battery in/from the the eBike, please read and observe the battery operating instructions.
Inserting and Removing the Drive HMI (see figure A) To insert the drive HMI, place it turned by approx. 30° onto holder 2 and then turn it clockwise to the stop. To remove the drive HMI, turn it approx. 30° anticlockwise and pull it out of the holder 2. f Remove the drive HMI when parking the eBike, so that the drive cannot be used by unauthorised persons. Without the drive HMI, the drive cannot be switched on.
Checking the Speed Sensor (see figure B) The speed sensor 9 and its spoke magnet 10 must be mounted in such a manner that the spoke magnet, after a turn of the wheel, moves past the speed sensor with a clearance of no more than 17 mm, max. Note: If the clearance between speed sensor 9 and spoke magnet 10 is too large or if the speed sensor 9 is not properly connected, the speed indication a will fail, and the eBike drive will operate in emergency mode. In this case, loosen the screw of the spoke magnet 10 and fasten the spoke magnet to the spoke in such a manner that it runs past the speed sensor with the lowest clearance possible. When the speed is still not being indicated in the speed indication a after this, please refer to an authorised bicycle dealer.
* Not possible via the eBike battery in all country-specific versions, depending on the statutory regulations
0 276 001 XXX | (17.1.11)
Bosch ebike Systems