Repairs IMPORTANT: Before welding on the machine, disconnect both battery cables from the battery and disconnect the terminal connector from the alternator to prevent damage to the electrical system.
Battery Service IMPORTANT: To prevent damage to electrical components, do not operate the engine with the battery cables disconnected.
Electrolyte Specific Gravity
Keep the terminals and entire battery case clean. To clean the battery, wash the entire case with a solution of baking soda and water. Rinse with clear water. Do not get the soda solution into the battery because damage to the battery will result. Coat the battery posts and cable connectors with skin-over grease, or petroleum jelly to prevent corrosion.
Battery Specifications
Fully charged: 1.250 - 1.280 Discharged: less than 1.240
BCI Group 26 SMF–5 Battery: 530 Amp Cranking Performance at 0o F (–17 o C) 85 min. Reserve Capacity at 80o F (27 o C)
Check for loose battery hold-downs. A loose battery may crack or cause the container to wear and leak acid. Check the electrolyte solution to make sure the level is above the plates. If the level is low (but above the plates inside the battery), add water so the level is to the bottom of the cap tubes. If the level is below the plates, add water only until the plates are covered and then charge the battery. After charging, fill the battery to the proper level.
CAUTION
1
2
Figure 29
Do not charge a frozen battery because it can explode and cause injury. Let the battery warm to 60o F (16o C) before connecting to a charger.
1. Positive (+) terminal 2. Negative (–) terminal
Charge the battery in a well-ventilated place so that gases produced while charging can dissipate. Since the gases are explosive, keep open flame and electrical spark away from the battery; do not smoke. Nausea may result if the gases are inhaled. Unplug the charger from the electrical outlet before connecting or disconnecting the charger leads from the battery posts.
Figure 30
Reelmaster® 335-D
Page 5 - 27
Repairs