Step
6
Press the (ENTER) key or use the key to move the cursor to the right-hand side, and then press the key again to display the menu shown below. If the distance adjustment is set for the setting area selected, the distance adjustment will be displayed here. Either press the (ENTER) key or move the cursor to the right-hand side and press the key. TANGENTIAL MODE 1
Step
7
Press the or key to select “Mode 1” or “Mode 2,” and then press the cut setting is displayed. STR=0.2
Step
(ENTER) key. The over-
END=0.2
8
“STR” indicates the initial overcut amount, and “END” indicates the end overcut amount for the line section. Press the or key to select “STR” or “END”, use the or key to increase or decrease the values, and then press the (ENTER) key to confirm. To cancel the selection(s), press the (NEXT) or (PREV.) key.
4–7