4.1
PAUSE Menu List
Pressing the (PAUSE) key in READY mode displays the PAUSE menu, enabling the various settings to be made. Select the required menu by scrolling through the list using the (NEXT) or (PREV.) key. MOVE TO R. MARK
4.2 Reading the Auto Registation Marks (Factory Option)
FEED
4.3 Setting the FEED function
AUTO PRE FEED
4.4 Setting the AUTO PRE-FEED
TANGENTIAL
4.5 Setting TANGENTIAL Mode
AUTO REG. MARK
4.6 Auto-Registration-Mark-Reading Settings (Factory Option)
CLEAR BUFFER
4.7 Clearing the Buffer Memory
AXIS ALIGNMENT
4.8 Aligning the Coordinate Axes
DISTANCE ADJUST
4.9 Distance Adjustment
PAGE LENGTH
4.10 Setting the PAGE LENGTH
PLOT AREA
4.11 Setting the Cutting/Plotting Area
EXPAND
4.12 Expanding the Cutting/Plotting Area
ROTATE
4.13 Rotating the Coordinate Axes
MIRROR
4.14 Mirroring
COPY
4.15 Cutting/Plotting Using the Buffer Memory (COPY Function)
SORT
4.16 Sorting Settings
RS-232C
4.17 Interface Settings
COMMAND
4.18 Setting the Format of Data to be Received
BLADE WEAR SETUP
4.19 Cutter-Blade Wear Detection
PEN UP/DOWN
4.20 Raising and Lowering the Pen
TEST
4.21 TEST Mode
PEN UP SPEED
4.22 Setting the PEN UP SPEED
OFFSET FORCE
4.23 Setting the OFFSET FORCE (Initial Cutting Force)
OFFSET ANGLE
4.24 Setting the OFFSET ANGLE
STEP PASS
4.25 Setting the STEP PASS
INIT. DOWN FORCE
4.26 Setting the INITIAL DOWN FORCE
LENGTH UNIT
4.27 Setting the LENGTH UNIT
(Special function only displayed for BLADE WEAR SETUP “ON’)
4–2