â– Control Panel Indicator Lamp STATUS:
Illuminates while the power to the cutting plotter is turned on, and goes out when the cutting plotter is in PAUSE status. This lamp flashes when data is being received from an interface, regardless of whether or not the cutting plotter is in PAUSE status.
Panel Keys TEST:
PREV.:
NEXT:
COND.: PAUSE:
ENTER:
ORIGIN:
1–6
Press this function key to conduct a cutting test and check the cutting conditions. Press this function key to view the previous display on the LCD when in PAUSE status. Press this function key to view the next display on the LCD when in PAUSE status. Press this function key to view the cutter-pen condition settings. Press this function key once in READY status to switch to PAUSE status in order to change the various settings. Press it again to cancel the PAUSE status. Pressing this key while cutting or plotting is in progress stops the cutting or plotting. Pressing this function key registers the cutting or plotting conditions set. POSITION: These keys are used to move the cursor or change the settings on the LCD display on the function setting screens. Press these keys when in PAUSE status to move the pen carriage or the medium. Press this function key to set the origin point. The pen position is set as the origin point when this key is pressed.