Function outputs 12.5. LGB® Pulse Sequence Mode
12.6. Swiss Head Light Mode
LokPilot V4.0
LokPilot V4.0 DCC
LokPilot V4.0
LokPilot micro V4.0
LokPilot micro V4.0 DCC
It is possible to switch to pulse sequence mode for operations with the LGB® command station and the Roco® Lokmaus I. To do so, set bit 5 in CV 49. From now on decoder counts the number of times the F1 button is pressed in order to activate the desired function. Thus, it is possible to reach all function buttons by repeated pushing of the F1 button.
LokPilot V4.0 DCC
Function mapping enables you to set many different configurations. The Swiss headlight mode is a good example. We need a third lighting circuit that switches the left lower headlight of the „A“- headlight configuration whenever the lights are turned on. This third circuit must work independently form the direction of travel. Figure 17 shows one option of how to wire this arrangement with AUX1 (green wire) being used for the third circuit. All you have to do now is to program the decoder in such a way that it always switches on that third circuit when the lighting function is active. In order to do so enter value 5 in CV 330 and value 6 in CV 346. (Don´t forget to firstly set the index register CV 31 to value 16 and CV 32 to value 2!). That´s it!
Rear bulbs
Head bulbs
yellow white green
= Light on = Light off Figure 17: Swiss Head Light mode
54