Page 15

Load chart CD3330FL YB4409XL boom YB4409XL3-section 3-section boom (Three-section boom)

3-SECTION MAIN BOOM

3-SECTION MAIN BOOM

3-SECTION MAIN BOOM

ON OUTRIGGERS (lb) Radius ON OUTRIGGERS (lb) F/R 360˚

Radius (ft) (ft) 5 5 6 6 8 8 10 10 12 12 14 16 14 18 16 20 18 22 20 24 22 26 24 27

F/R

Radius Radius (ft)

360˚

17,000 15,700 17,000 12,400 15,700 10,200 12,400 8500 10,200 7100 8500 6000 7100 5200 6000 4450 5200 3800 4450 3300 3800 2900 3300 2750

3-SECTION MAIN BOOM W/6 FT JIB DEPLOYED 3-SECTION MAIN BOOM W/6 FT JIB DEPLOYED LOADED ON OUTRIGGERS (lb) ON RUBBER (lb) LOADED Radius BOOM ON OUTRIGGERS (lb) ON RUBBER (lb) BOOM Radius ANGLE (ft) 360˚ F/R 360˚ ANGLE F/R (ft) (deg)

3-SECTION MAIN BOOM

(ft)

5 65 86 108 12 10 14 12 16 14 18 16 20 18 22 20 24 22 26 24 27

17,000 14,400 17,000 10,800 14,400 8500 10,800 6950 8500 5800 6950 4650 5800 3800 4650 3150 3800 2700 3150 2350 2700 2050 2350 1925

ON RUBBER (lb)

ON RUBBER (lb)

F/R

F/R

10,000 9500 10,000 7325 9500 4875 7325 3550 4875 2750 3550 2150 2750 1775 2150 1450 1775 1225 1450 1025 1225 875 1025 850

360˚

360˚

10,000 8200 10,000 5125 8200 3475 5125 2550 3475 1925 2550 1450 1925 1150 1450 950 1150 800 650950 525800 475650

16.4 18 16.4 20 18 22 20 24 22 26 24 28 26 30 32 28 33.5 30

32 33.5

(deg) 3500 F/R 3500 360˚ 2000 3375 3500 3375 35001775 3225 3375 3150 33751450 3075 3225 2700 3150 1225 2950 3075 2350 27001025 2850 2950 2050 2350 875 2625 800 1825 2850 1650 2050 725 2400 1825 650 2175 2625 1475 2000 2400 1375 1650 600 2175 16.5 1475 2000 0 1375

60 57.5 60 53.5 57.5 49 53.5 44.5 49 39.5 44.5 34 39.5 27 16.5 34 27 0

26 26 875 2900 525 2050 27 27 850 2750 1925 NOTES: 1) The rated475 loads are the maximum OPERATE WITH JIB BY RADIUS WHEN MAIN lifting capacities as determined BOOM IS FULLY EXTENDED AND BY BOOM ANGLE by operating radius only. Any WHEN MAIN BOOM IS PARTIALLY EXTENDED. DO combination of boom lengths NOT EXCEED JIB CAPACITIES AT ANY PARTIALLY and angles may be used to obtain EXTENDED BOOM LENGTH. operating radius. The operating radius is the horizontal distance SHADED AREAS ARE GOVERNED BY STRUCTURAL from a projection of the axis of STRENGTH. DO NOT RELY ON TIPPING. rotation to the supporting surface, before loading, to the center of OPERATION OF THIS EQUIPMENT IN EXCESS OF vertical hoist line or tackle with load RATING CHARTS AND DISREGARD OF applied. INSTRUCTIONS IS DANGEROUS AND VOIDS WARRANTY. 2) The rated loads shown on outriggers do not exceed 85% of actual tipping. The rated loads shown on SIDE rubber do not exceed 75% of actual 15˚ 15˚ tipping. These ratings are based 30˚ 30˚ on freely suspended loads with the REAR FRONT SIDE crane leveled, standing on a firm, SIDE uniform, supporting surface. Practi15˚ 15˚ cal working loads depend on sup30˚ 30˚ REDUCTION CHART porting surface, operating radius, REAR FRONT FROM FROM MAIN BOOM JIB and other factors affecting stability. RATINGS RATINGS SIDE Hazardous surroundings, climatic N/A 140 lb MAIN BLOCK conditions, experience of personREDUCTION CHART HOOK & BALL 100 lb 100 lb nel, and proper training must all be FROM FROM MAIN BOOM JIB taken into account by the operator. JIB, STOWED N/A 0 lb RATINGS

RATINGS

150lb lb 140

0 lb N/A

JIB, DEPLOYED MAIN BLOCK

HOOK & BALL RIGGING 100 lbCHART JIB, STOWED

0 lb

JIB, DEPLOYED

150 lb

1-PART 0 - 8500 lb

100 lb N/A

2-PART 0 - 17,000 lb

0 lb

F/R

360˚

650 600

1300 1150 950 800 650 525 425 350 300 250

1300 1150 2000 950 1775 800 1450 650 1225 525 1025 425 875 350 800 300 725 250

4) Ratings on outriggers are with outriggers fully extended. 5) Ratings on rubber depend on tire capacity, condition of tires and proper inflation pressure (100 psi). Loads on rubber may be transported at a maximum speed of 2.5 mph on a smooth, hard, level surface with boom retracted to the shortest length possible and centered over front. 6) For operating radius not shown, use load rating of next larger radius. 7) The maximum combined total boom and deck load is 12,000 lb. The maximum deck load only is 14,000 lb. 8) Do not induce any external side loads to boom or jib. 80017679CD

3) The weights of all load handling devices such as hooks, hook blocks, slings, etc., except the hoist rope, shall be considered as part of the load. See reduction chart.

WIRE ROPE: 1/2 inch diameter Minimum breakingCHART strength 29,750 lb RIGGING

1-PART 0 - 8500 lb

2-PART 0 - 17,000 lb

WIRE ROPE: 1/2 inch diameter Minimum breaking strength 29,750 lb

Shuttlelift CD3300 Series

THIS CHART IS ONLY A GUIDE AND SHOULD NOT BE USED TO OPERATE THE CRANE. The individual crane’s load chart, operating instructions and other instructional plates must be read and understood prior to operating the crane.

15

Shuttlelift-3339-Series-Product-Guide  

http://arabiancrane.com/images/Grove-Mobile-Cranes/Shuttlelift-Carrydeck/Shuttlelift-3339-Series-Product-Guide.pdf

Advertisement