BLASTER PERFORMANCE COILS IGNITIONS
COIL SPECIFICATIONS TURNS RATIO: 100:1 PRIMARY RESISTANCE: .7 OHMS SECONDARY RESISTANCE: 4.5K OHMS
Lower resistance and improved turns ratio produces a powerful spark for improved performance!
PN 8200, 10K 8 MH 45,000 VOLTS 140 MA 350 US
TESTED WITH 6AL IGNITION AT PLUG GAP THESE PRODUCTS ARE OBD II LEGAL TO SELL, DISTRIBUTE OR INSTALL ON 2003 OR OLDER VEHICLES IN CALIFORNIA ACCORDING TO EXECUTIVE ORDER E.O. D-40-37; LEGAL IN ALL 50 STATES.
COILS
OBD II
INDUCTANCE: MAXIMUM VOLTAGE: PEAK CURRENT: SPARK DURATION:
LATE MODEL
If you are looking to upgrade your stock coil or want to complement the performance of your MSD 6-Series Ignition, our Blaster Coils are the right choice.
ALT/STARTERS DISTRIBUTORS
LEGAL FOR USE IN ALL STATES
FOR MSD IOBD GNITION APPLICATIONS II
PN 8202
The following BlasterLEGAL Coils share the same special windings and high voltage FOR USE IN ALL STATES output as the other Blaster 2 coils, but do not include a ballast resistor. When you are using an MSD Ignition Control, the Ignition is responsible for delivering the voltage to the coil so a ballast resistor is not necessary.
The Blaster 3 Coil features an extra tall tower design to improve the coil wire attachment and spark isolation. Supplied with a 90° terminal and boot.
CRANK TRIGGERS
Blaster 2, Red - PN 8202 Blaster 3 - PN 8223 PN 8223
TIMING/RPM CONTROLS
Blaster 2F - PN 8205 This coil features the same “horseshoe” connector that the stock Ford Duraspark Ignitions have so there is no need to cut the wires!
BLASTER HIGH VIBRATION COIL TM
SPARK PLUG WIRES
In applications such as off-road, marine or other harsh conditions, the MSD Blaster High Vibration Coil is the best choice. The sturdy metal housing of the High Vibration Coil is completely potted with a premium grade epoxy to completely encase the coil’s primary and secondary windings. This protects the coil’s internal components from high and low frequency vibrations that are commonly experienced in racing.
PN 8205
ACCESSORIES
High Vibration Blaster - PN 8222
BLASTER COILS FOR POINTS, ELECTRONIC OR MSD IGNITIONS TM
PN 8222
STREET FIRE
NOTE: The ballast is not necessary if an MSD 6 or 7-series Ignition Control is being used with the points distributor.
PN 8200
FOR MORE INFORMATION ON: Coil Brackets, see page
52
PROMO
Blaster 2 Kit, Chrome - PN 8200 Blaster 2 Kit, Red - PN 8203
MARINE
With a stock points style ignition, a ballast resistor must be placed in-line with the positive terminal of the coil. The following Blaster Coils are supplied with a 0.8 ohm ballast resistor plus a terminal and boot to fit most applications. Mallory Unilite applications also require the ballast resistor.
*Not legal for use or sale on pollution controlled vehicles.
MSD TECH LINE 915-855-7123
47_cat.indd 1
47 9/28/2009 8:46:29 AM