Page 1

v THERMODYNE


v THERMODYNE

ď ˝

A thermal fluid heater is a closed loop using thermic fluid as the heat transfer fluid. These systems operate at elevated temperatures while maintaining low system pressures.


Oil Fired Thermic Fluid Heater

Gas Thermic Fluid Heater

Solid Fuel Fired Thermic Fluid Heater


v THERMODYNE


v THERMODYNE

Thermic Fluid Heating system is a fully automatic packaged, oil/gas fired 3 pass heater in which Thermic fluid can be heated up to 300° C almost at atmospheric pressure.

Thermic fluid heater is a closed circuit unit in which a hot thermic fluid is circulated. The heat is transferred to process through a heat exchanger in user equipment.


v THERMODYNE

Multi-Start Coil Radiation Coil Convection Coil

Furnace


v THERMODYNE

The flame travels inside the Thermic Fluid in 3-passes: ◦ 1st pass – Vertically down from the burner ◦ 2nd pass – Travels vertically up in the gap between outer coil and the inner coil. ◦ 3rd pass – Travels vertically down in the gap between outer coil and the inner shell. ◦ In all the three passes, the heat of flue gases is passed on to the Thermic oil inside the coil and the circulation of T.F. oil is in closed cycle, therefore after some time temp of Thermic fluid rises up to 300 degree.


v THERMODYNE

Temperature indicator cum Controllers to indicate temperature and prevent undesired overheating at the inlet and outlet of the system Stack temperature controller to cut off the Thermic Fluid Heater when the flue gas temperature exceeds the set level and to act as a counter check for temperature indicator cum controller at oil outlet line Photo cell to sense flame failure, give alarm and switch off the burner Magnetic level switch in the deareator cum expansion tank to cut off the burner if the thermic fluid level falls below the minimum level Synchronising mechanism exists between the hot oil circulation pump and burner, so that the burner will not be switched on until the circulation pump reached the full speed


v THERMODYNE


v THERMODYNE

       

Oil / Gas / Solid Fuel Fired fully automatic thermic fluid heaters No water treatment required Outside the purview of IBR Thermic fluid can be heated up to 300° C almost at atmospheric pressure Fully automatic unit maintains the required temperature of Thermic Fluid Heater Most suitable for high-temperature heating Minimum site work and easy installation Minimum site Work reduces installation price


v THERMODYNE

        

Chemicals Textiles Plastic & Rubber Plywood & Laminates Metal Finishing Food Industry Packaging Oils Confectionery etc


v THERMODYNE

v

THERMODYNE ENGINEERING SYSTEMS A-7 / 108 & 110, SSGT Road Industrial Area, Ghaziabad, U.P. – 201009 Email: sales@thermodyneboilers.com Website: www.thermodyneboilers.com

Thermic fluid heater - Fluidtherm  
Thermic fluid heater - Fluidtherm  

Fluidtherm or commonly known as Thermic Fluid Heater is the most efficient and highly effective in process heating equipment which uses high...

Advertisement