Page 1

JN0-350 ER.Specialist(JNCIS-ER)

↘

http://www.testsexpert.com/JN0-350.html


Question: 1 In the exhibit:

You configure R1 and R2 to export RIP routes to OSPF and OSPF routes to RIP. Users in the RIP network are complaining about connectivity to users in the OSPF network. What are two possible causes of the problem? (Choose two.) A - RIP is not a link-state protocol. B - RIP has a lower preference than OSPF. C - Export policy is allowing a routing loop to form. D - The correct RIP routes are not exported to OSPF.

Answer: C, D Question: 2 What information can be gathered using traceoptions? (Choose two.) A - chassis status B - firewall counters C - routing protocol information D - interface operational information

Answer: C, D

www.testsexpert.com

2


Question: 3 In the exhibit:

How many internal BGP sessions are needed on Router 6 if all routers are running BGP and no route reflection or confederations are being used? A-1 B-3 C-5 D-6

Answer: C Question: 4 Which two statements are true regarding IPSec VPN service rules configured at the [edit services ipsec-vpn] hierarchy? (Choose two.) A - Each term can specify a different lPSec policy. B - Each term can specify a different local gateway. C - Each term can specify a different remote gateway. D - Each term can match multiple source and destination prefixes.

Answer: A, C

www.testsexpert.com

3


Question: 5 In the: [edit services] lab@R1# show stateful-firewall { rule my-rule [ match-direction input-output; term 1{ from { source-address-range { low 1.2.3.4 high 1.2.3.4; } } then { accept; } } } } service-set my-services-set { stateful-firewall-rules my-rules; interface-service { service-interface sp-0/0/0.0; } } What will the router do when it receives a packet from source address 10.10.10.10 on an interface where the my-service-set service set is applied? A - Send a TCP RST. B - Accept the packet. C - Silently discard the packet. D - Send an ICMP error message.

Answer: C

www.testsexpert.com

4


Question: 6 The re-protect firewall filter is applied as an input filter on the lo0.0 interface. [edit firewall filter re-protect] lab@host#show term one { from { source-address { 10.0.0.1/32; } then accept; } term three { then { reject; } } You have a single BGP peering session with 10.0.0.1. Which statement is true? A - term two has an incorrect match condition. B - term one has an incorrect match condition. C - term one is necessary for the correct operation of BGP. D - term three is necessary for the correct operation of BGP.

Answer: C Question: 7 Which two statements are true about scheduler maps? (Choose two.) A - A default scheduler map is applied to each interface. B - A scheduler map is only needed on low speed interfaces. C - A scheduler map is applied before a multifield firewall filter. D - A scheduler map controls the resources assigned to a specific queue.

Answer: A, D Question: 8 Your Juniper WAN router is connected to an Ethernet switch that is configured to use 802.1p bits for classifying traffic. Which statement is correct about the configuration of CoS on the router? A - You can only use multifield rewrites for this traffic. B - You can only use multifield classifiers for this traffic. C - By default the router will use the 802.1p bits for classification. D - Additional configuration is needed to use the 802.1 bits for classification.

Answer: D

www.testsexpert.com

5


Question: 9 Which two statements about policers are correct? (Choose two.) A - You can only police traffic once per direction. B - Policers can only be configured using firewall filters. C - Policers are useful against Denial of Service (DoS) attacks. D - Traffic exceeding the policer can be dropped or reclassified.

Answer: C, D Question: 10 In the: term testing-1-2-3 { from { route-filter 10.0.0.0/16 or longer accept; route-filter 10.0.67.0/24 or longer accept; route-filter 192.168.64/18 or longer reject; route-filter 192.168/16 or longer accept; } then { metric 10; accept; } } What would the result be when the prefix 10.0.67.43/32 is evaluated by the term? A - No match is found. B - The route would be rejected. C - The route would be accepted with no modifications. D - The route would be accepted with the metric set to 10.

Answer: D

www.testsexpert.com

6


You will not find better practice material than testsexpert PDf questions with answers on the web because it provides real exams preparation environment. Our practice tests and PDF question, answers are developed by industry leading experts according to the real exam scenario. At the moment we provides only question with detailed answers at affordable cost. You will not find comparative material elsewhere on the web at this price. We offer Cisco, Microsoft, HP, IBM, Adobe, Comptia, Oracle exams training material and many more.

We also provide PDF Training Material for: Cisco CCNA CCNP CCIP CCIE CCVP CCSP CXFF CCENT CCDE

Microsoft MCTS MCSE MCITP MBS MCPD MCAD MCAS MCSA MCDBA

HP AIS APC APS ASE CSA MASE APP CSD CSE

IBM Adobe Comptia Oracle Lotus CS4 A+ 11g DBA WebSphere CS3 Security+ 10g DBA Mastery ACE Server+ OSA 10g SOA CS5 Network+ OCA 9i Storage CS2 Linux+ 11i Rational Captivate iNet+ 9i Forms Tivoli Flex Project+ Weblogic IBM DB2 CSM RFID+ Oracle 8i IBM XML MX7 HTI+ PTADCE

We provide latest exams preparation material only. Contact US at: support@testsexpert.com Join Us at Twitter: www.twitter.com/testsexpert FaceBook: www.facebook.com/testsexpert

www.testsexpert.com

7

JN0-350 JUNIPER Exam Answers  

JN0-350 JUNIPER exam asnwers free download JN0-350 detailed JN0-350 test answers sample. Buy JUNIPER JN0-350 study materials.

Read more
Read more
Similar to
Popular now
Just for you