Reduces process times,
Typical damage: stone chip damage or small scratch.
Clean with Standox Silicone Remover.
Sand the damaged area using a sanding machine suitable for the MicroRepair method. Then clean again. If damage goes through to bare metal, use 1K Fullprimer before next stage.
Applying filler & drying
Mask the area. Apply Standox 2K HS Filler. Infrared or oven dry.
Sand the area. Then clean with Standohyd Cleaner.
Additional information Gun set up: 1.1–1.2 mm at 1–1.5 bar Basecoat application: Thin with 15% deionised water and apply to opacity. Using Colour Blend: Mix 1 : 1 with Standohyd basecoat. Using Smart Blend or Smart Blend Mild: Mix 5 : 1 with activated Standox HS Repair Clear.
Areas recommended for MicroRepair. Areas not recommended for Micro Repair.
● Minimizes repair area ● Reduces labour cost ● Increases productivity
Final cleaning with an antistatic, dust removing cloth.
Apply Standohyd Basecoat to opacity and blend with Colour Blend if necessary.
● Reduces bottlenecks
For more information please refer to your Standox Product information manual.
Applying clearcoat & drying
Apply 2K HS Repair Clear over basecoat, then blend in using Standox 2K Smart Blend or Smart Blend Mild. Infrared or oven dry.
Final polishing with the spot polishing machine.
A top-class repair for a top-class vehicle.
Technical Service Tel: 020 8598 4292 Fax: 020 8598 4520 02/03
Standox Micro Repair System Chart