Power Train 4-Speed Transaxle
rractors, 200 Series SM-2105 (Ocf- 76)
Idler Gear and Pinion Shaft
Input Shaft and Gear
A-Thrust Washer B-Chamfered Gear Spline
50 20-1 1
C-Input
Shaft
8 1 6730@Y,
C P i n i e n Shaft &Pinion Shaft Bearing E-Beveled Edge on Teeth
A-Thrust Washer B-Idler Gear
Frg. 25-input Shaft and Gear
Assemble input shaft (C), gear, and thrust washer (A). Chamfered gear spline (8) must be toward outer end of shaft (C) as shown in Fig. 25. Gear is a hghE press fit onto shaft. *
*
Frg 27-Idler Gear and ShaH
Use seal sleeve tool listed ~nSection 80 - "Special Tools", and assemble thrust washer (A), idler gear (B),and pinion shaft (C) as shown in Fig. 27. Beveled edge on teeth (E) must face away from pinion shaft (C) as shown. Pinion shaft is a light press fit through idler gear. r$
t
%
A-Shifter Rod Sockets C-Flat B-Washer, Input Shaft and Gear Assembly
Side of Gear
Fig. 26-Assembled Input Shaft
Install washer, input shaft and gear assembly (B} into case as shown. Use special tool to protect seal when slipping shaft through seal. Refer to Section 80 - "special ~ o o l s "for proper seal sleeve. Flat side of gear (C) should now face upward, Fig. 26.
Litho in U.S.A.
-%
7
A-Pinion
1
--
L+L-
,<*+ 9%
ao$-k.
r
Shaft, Idler and Washer 6-Flat
Edge of Gear Up
Fig. 28-Idler Gear and Shaf! Assembly
When thrust washer, idler gear, and pinion shaft properly assembled and installed, they will (A) appear as shown in Fig. 28. The flat edge of the tdler gear (B) should now face upward.