YAMAHA YFZ-450R REVOLUTION HEEL GUARD PLATES (Y099075) INSTALLATION INSTRUCTIONS
Please read these instructions carefully before installation to prevent injury to yourself or damage to your ATV. PARTS LIST: PART
HEEL GUARD PLATE (LEFT)
HEEL GUARD PLATE (RIGHT)
NOTE: These heel guard plates are to be installed with the Y099077 Fat Peg Revolution Nerf Bar application.
1. Locate heel guard mounting hardware from Y099077 Fat Peg Revolution Nerf Bar kit. The hardware should be as follows: M6 x 16mm button head bolts (Qty-16), M6 nyloc nuts (Qty-16) and 6mm washers (Qty-16) . INSTALLATION:
1. Position the left heel guard plate so that it rests against and is aligned with the heel guard mounting tabs of the left Fat Peg Revolution Nerf Bar. 2. Secure the heel guard plate in place by installing (1) M6 x 16mm button head bolt, (1) 6mm washer and (1) M6 nyloc nut at each of the mounting tab locations (8) as shown in the diagram below. LEFT NERF BAR AND HEEL GUARD SHOWN
3. Repeat the procedure for the right heel guard plate on the right side nerf bar. MAINTENANCE:
Periodically check all mounting hardware for tightness. Re-torque bolts and fasteners when needed. Make sure that the heel guard is properly installed before use. Do not operate the vehicle if any bolts or fasteners are loose or missing. CUSTOMER SERVICE:
For further information, please contact PRO ARMOR at 1-951-343-9270. Y099075
Published on May 23, 2012
CUSTOMER SERVICE: INSTALLATION INSTRUCTIONS PREPARATION: 1. Locate heel guard mounting hardware from Y099077 Fat Peg Revolution Nerf Bar kit...