Page 1

YAMAHA RAPTOR 250 (Y085035) SWING ARM GUARD INSTALLATION INSTRUCTIONS Please read these instructions carefully before installation to prevent injury to yourself or damage to your ATV. PARTS LIST: ITEM

DESCRIPTION

QTY

1

SWING ARM GUARD

1

2

M6 x 20mm FLANGE HEX BOLT

4

2

PREPARATION:

1. For easier installation, set the parking brake on the vehicle and stand the bike up so that it rests on its rear grab bar. 2. Remove the plastic factory swing arm guard and discard the mounting hardware.

1

INSTALLATION:

1. Position the Pro Armor swing arm guard in place of the factory swing arm guard aligning the mounting holes on the guard to the mounting points located on the vehicle’s swing arm. 2. Loosely install (1) M6 x 20mm flanged hex bolt at each of the (4) mounting points. With all mounting points located and hardware loosely installed, tighten down the mounting bolts securing the swing arm guard to the vehicle’s swing arm. MAINTENANCE:

Periodically check to see that the swing arm guard is securely installed on the vehicle. Re-torque bolts if necessary. Do not operate the vehicle if any bolts or fasteners are loose or missing. CUSTOMER SERVICE:

For further information, please contact Pro Armor at 1-951-343-9270.

Y085035

Y085035_Rap250SwingArm_Instructions  

Periodically check to see that the swing arm guard is securely installed on the vehicle. Re-torque bolts if neces- sary. Do not operate the...

Advertisement