Page 1

INSTRUCTIONS SUZUKI LT-R450 Kill Switch Install Kit To avoid injury to your self or damage to the ATV, read these instructions carefully before installation. ProArmor Part #A040021 Kill Switch is required. 1. Parts List: Item 1 2 3 4

Part Name Wiring Harness Ground Wire Bullet Connector Bullet Connector

Description Female Male

Qty 1 1 1 1

2. Preparation: a) Remove coil mounting bracket from the right side of the bike. Retain all mounting hardware for later re-installation. Remove 3 bolts

b)

Locate and disconnect plastic clip from the coil.

3. Installation: a) Install Item #1 wiring harness into plug disconnected in step B above. b) Crimp Item #3 onto either of the wires coming out of your kill switch. Crimp the other wire from the kill switch onto Item #4 connector. c) Connect Item #2 with Item #3 installed on your kill switch. d) Connect Item #4 with Item #1 harness installed on your bike. S061001


e) f) g) h)

Install the ring terminal with any convenient bolt that mounts to the frame as your ground wire. Test the kill switch by starting the bike with the teather in the switch. After bike warms up, pull the teather. If kill switch works, re-install coil mounting bracket with OE hardware. If kill switch does not work, check all electrical connections. Then check kill switch for continuity.

4. Customer service:

For further information call Pro Armor at 951-270-0559

S061001

S061001_LTR450KillSwitch_Instructions  

3. Installation: a) Install Item #1 wiring harness into plug disconnected in step B above. b) Crimp Item #3 onto either of the wires coming...

Advertisement