Page 1

YAMAHA RAPTOR700 Pro-Am GRAB BAR (Y063460) INSTALLATION INSTRUCTIONS

Please read these instructions carefully before installation to prevent injury to yourself or damage to your ATV. PARTS LIST: PART 1

DESCRIPTION GRAB BAR

QTY 1

HARDWARE KIT 2

PART 2 3

DESCRIPTION 6mm WASHER M6 NYLOC NUT

QTY

1

2 2 3

PREPARATION:

1. Remove the factory grab bar retaining all mounting hardware and tail light hardware including all rubber grommets. INSTALLTION:

1. Position the ProAm grab bar in place of the OEM grab bar aligning the (4) mounting points on the frame to the mounting points on the grab bar. With a box cutter, trim the left side fender along the dotted line shown to the right to allow fitment of the ProAm grab bar. 2. Re-install the mounting bolts at the (4) aligned side mounting points. Torque the bolts to 18.5 ft./lbs. 3. Re-install the tail light onto the ProAm grab bar using the retained tail light hardware and rubber grommets. 4. Mount the grab bars fender mounts to the vehicle’s fenders by installing (2) 6mm washers and (2) M6 nyloc nuts along with (2) retained fender mounting bolts.

MAINTENANCE:

Periodically check to see that the grab bar is securely installed. Re-torque bolts when necessary. Do not operate the vehicle if any hardware is loose or missing. CUSTOMER SERVICE:

For further information, please contact PRO ARMOR at 1-951-343-9270.

Y063460

ProAm_Y063460_Rap700GrabBar_Instructions  

Pro-Am GRAB BAR (Y063460) MAINTENANCE: CUSTOMER SERVICE: INSTALLATION INSTRUCTIONS PREPARATION: INSTALLTION: For further information, please...

Advertisement