YAMAHA RAPTOR700 Pro-Am GRAB BAR (Y063460) INSTALLATION INSTRUCTIONS
Please read these instructions carefully before installation to prevent injury to yourself or damage to your ATV. PARTS LIST: PART 1
DESCRIPTION GRAB BAR
HARDWARE KIT 2
PART 2 3
DESCRIPTION 6mm WASHER M6 NYLOC NUT
2 2 3
1. Remove the factory grab bar retaining all mounting hardware and tail light hardware including all rubber grommets. INSTALLTION:
1. Position the ProAm grab bar in place of the OEM grab bar aligning the (4) mounting points on the frame to the mounting points on the grab bar. With a box cutter, trim the left side fender along the dotted line shown to the right to allow fitment of the ProAm grab bar. 2. Re-install the mounting bolts at the (4) aligned side mounting points. Torque the bolts to 18.5 ft./lbs. 3. Re-install the tail light onto the ProAm grab bar using the retained tail light hardware and rubber grommets. 4. Mount the grab bars fender mounts to the vehicleâ€™s fenders by installing (2) 6mm washers and (2) M6 nyloc nuts along with (2) retained fender mounting bolts.
Periodically check to see that the grab bar is securely installed. Re-torque bolts when necessary. Do not operate the vehicle if any hardware is loose or missing. CUSTOMER SERVICE:
For further information, please contact PRO ARMOR at 1-951-343-9270.
Published on May 22, 2012
Pro-Am GRAB BAR (Y063460) MAINTENANCE: CUSTOMER SERVICE: INSTALLATION INSTRUCTIONS PREPARATION: INSTALLTION: For further information, please...