Page 1

YAMAHA RAPTOR 700 ProAm SWING ARM GUARD (Y063435) INSTALLATION INSTRUCTIONS

Please read these instructions carefully before installation to prevent injury to yourself or damage to your ATV. PARTS LIST: PART 1

DESCRIPTION SWING ARM GUARD

QTY 1

HARDWARE KIT PART 2 3

DESCRIPTION M6 x 20mm HEX BOLT 6mm WASHER

2

QTY 4 2 1

3

PREPARATION:

1. Set the vehicle’s parking brake and stand the vehicle upright so that it rests on its rear grab bar. Make sure that the vehicle is secure and will not fall over while installing the swing arm guard. 2. Remove the plastic factory swing arm guard from the vehicle. INSTALLATION:

1. Position the Pro Am swing arm guard in place of the factory swing arm guard aligning its mounting holes to the mounting points on the vehicle’s frame. Use the diagram below as a guide for hardware installation.

INSTALL (2) M6 x 20mm HEX BOLTS. POSITION (2) WASHERS BETWEEN THE SWING ARM GUARD AND THE ATV’S SWING ARM. INSTALL (2) M6 x 20mm HEX BOLTS.

MAINTENANCE:

Periodically check to see that the swing arm guard is securely installed. Re-torque bolts when necessary. Do not operate the vehicle if any hardware is loose or missing. CUSTOMER SERVICE:

For further information, please contact PRO ARMOR at 1-951-343-9270. Y063435

ProAm_Y063435_Rap700SwingArm_Instructions  

CUSTOMER SERVICE: INSTALLATION INSTRUCTIONS PREPARATION: 1. Position the Pro Am swing arm guard in place of the factory swing arm guard alig...

Advertisement