Page 1

HONDA TRX450R ProAm GRAB BAR (H062460) INSTALLATION INSTRUCTIONS

Please read these instructions carefully before installation to prevent injury to yourself or damage to your ATV. PARTS LIST: PART 1

DESCRIPTION REAR GRAB BAR

QTY 1

PREPARATION:

1. Disconnect the vehicle’s tail light and remove the OEM grab bar retaining the (4) upper mounting bolts. and the exhaust mounting hardware/rubber grommets. 2. Remove the tail light from the OEM grab bar retaining all bolts, fasteners and rubber grommets. INSTALLATION:

1. Re-install the tail light on the ProAm rear grab bar using the retained tail light mounting hardware. Re-install the rubber grommet used for the exhaust mount onto the grab bar as well. 2. Position the ProAm rear grab bar in place of the OEM grab bar and loosely re-install the (4) retained upper mounting bolts along with the exhaust mounting hardware. 3. With all mounting points located and hardware loosely installed, re-connect the tail light and tighten the mounting bolts securing the rear grab bar to the frame of the vehicle. MAINTENANCE:

Periodically check to see that the grab bar is securely installed. Re-torque bolts when necessary. Do not operate the vehicle if any hardware is loose or missing. CUSTOMER SERVICE:

For further information, please contact PRO ARMOR at 1-951-343-9270.

H062460

ProAm_H062460_TRX450RGrabBar06_Instructions  

ProAm GRAB BAR (H062460) MAINTENANCE: CUSTOMER SERVICE: INSTALLATION INSTRUCTIONS PREPARATION: INSTALLATION: For further information, please...

Advertisement