Page 1

HONDA TRX450R Pro-Am SWING ARM GUARD (H042435) INSTALLATION INSTRUCTIONS

Please read these instructions carefully before installation to prevent injury to yourself or damage to your ATV. PARTS LIST: PART 1

DESCRIPTION SWING ARM GUARD

QTY 1

1 2

HARDWARE KIT PART

DESCRIPTION

QTY

2 3 4

M8 x 20mm SOCKET HEAD BOLT M8 x 20mm FLANGE HEAD BOLT 8mm WASHER

4 2 4

3

4

PREPARATION:

1. Lock the vehicle’s rear parking brake, turn the gas petcock to off and stand the vehicle upright so that it sits on it’s rear grab bar. Make sure the vehicle is secure and will not fall over during installation. 2. Remove and discard the (6) OEM bolts mounting the existing factory swing arm guard to the vehicle’s swing arm. Remove and discard the factory swing arm guard. INSTALLTION:

1. Position the ProAm swing arm guard in place of the factory guard aligning the mounting holes of the swing arm guard to the mounting points located on the vehicle’s swing arm. 2. Install the specified hardware as shown in the diagram to the right.

UPPER/LOWER MOUNTING POINTS: (1) SOCKET HEAD HEX BOLT AND (1) 8mm WASHER FOR EACH

MID MOUNTING POINTS: (1) FLANGE HEAD HEX BOLT FOR EACH

MAINTENANCE:

Periodically check to see that the swing arm guard is securely installed. Re-torque bolts when necessary. Do not operate the vehicle if any hardware is loose or missing. CUSTOMER SERVICE:

For further information, please contact PRO ARMOR at 1-951-343-9270. H042435

ProAm_H042435_TRX450RSwingArmGuard_Instructions  

1. Lock the vehicle’s rear parking brake, turn the gas petcock to off and stand the vehicle upright so that it sits on it’s rear grab bar. M...