Page 1

HONDA TRX400EX ProAm SWING ARM GUARD (H011435) INSTALLATION INSTRUCTIONS Please read these instructions carefully before installation to prevent injury to yourself or damage to your ATV.

PARTS LIST: PART 1

DESCRIPTION SWING ARM GUARD

QTY 1

1

PREPARATION:

1. Lock the vehicle’s rear brake, turn off gas petcock valve, plug the gas tank vent hose and stand the bike up so that it rests on its rear grab bar. 2. Remove the plastic factory swing arm guard retaining the (4) factory 8mm mounting bolts.

INSTALLATION:

1. Position the ProAm swing arm guard in place of the plastic factory swing arm guard. Align the mounting holes of the swing arm guard to the mounting points on the vehicle’s swing arm. Loosely install (1) retained factory 8mm bolt at each of the (4) mounting points. When all mounting hardware is loosely installed, tighten down the mounting bolts securing the ProAm swing arm guard to the vehicle’s swing arm.

MAINTENANCE:

Periodically check to see that the swing arm guard is properly installed. Re-torque bolts and fasteners when needed. Do not operate the vehicle if any bolts or fasteners are loose or missing. CUSTOMER SERVICE:

For further information, please contact PRO ARMOR at 1-951-343-9270.

H011435

ProAm_H011435_TRX400EXSwingArm_Instructions  

MAINTENANCE: Periodically check to see that the swing arm guard is properly installed. Re-torque bolts and fasteners when needed. Do not ope...

Advertisement