Page 1

HID LIGHT KIT (P081301) FOR APPLICATION(S): 2008-UP POLARIS RAZR 2008-UP POLARIS RANGER 2006-UP ARCTIC CAT PROWLER 2008-UP ARCTIC CAT THUNDERCAT

INSTALLATION INSTRUCTIONS INSTALLATION: BULB: A. Remove the stock bulb (twist counterclockwise). B. CAUTION: PLEASE BE CAREFUL THAT YOUR SKIN DOES NOT MAKE CONTACT WITH THE GLASS PORTION OF THE HID BULBS.

C. Insert HID bulb and twist clockwise to lock into position. BALLAST: A. Mount the ballast in the location of your choice near the headlight. Make sure that the ballast is

securely mounted at that location. WIRING: NOTE: DO NOT modify the wiring that runs from the HID bulb to the ballast. It will cause the

system to work improperly. It will void the warranty. A. Once the ballast is installed, connect the corresponding wires from the HID bulb to the corresponding male/female plugs on the ballast. B. To connect the wiring from the ballast to the vehicle primary system: I. Find the wire extension male plug removed from the original factory bulb. II. Connect the black wire to the black wire coming off of the ballast. III. Connect the red wire to the red wire coming off of the ballast. IV. Connect the black female plug head to the corresponding plug on the vehicle. NOTES: Upgrading to a 20AMP fuse is recommended. Each HID light draws only 2.9 amps per light, but upon

start-up, for approximately 10 seconds they draw around 16AMPS. This can cause 1 or both lights to not light up. If this situation occurs, the 20AMP fuse will solve the problem. WARNING! Please be sure that the HID light connectors are plugged in correctly! The connector plugs do

not have a lock out, allowing them to be plugged in backwards.

CUSTOMER SERVICE: For further information, please contact PRO ARMOR at 1-951-343-9270.

P081301_HIDLIGHTKIT_Instructions  

BULB: A. Remove the stock bulb (twist counterclockwise). B. CAUTION: PLEASE BE CAREFUL THAT YOUR SKIN DOES NOT MAKE CONTACT WITH THE BALLAST...

Advertisement