Page 1

KAWASAKI TERYX 750 (K082044) LEG GUARDS INSTALLATION INSTRUCTIONS Please read these instructions carefully before installation to prevent injury to yourself or damage to your vehicle. PARTS LIST: PART

DESCRIPTION

QTY

1

LEG GUARD (LEFT)

1

2

LEG GUARD (RIGHT)

1

1 3

HARDWARE KIT: PART

DESCRIPTION

QTY

3

SELF-TAPPING SCREW

5

4

FOAM RUBBER STRIP

2

4

2

PREPARATION: 1. Remove and retain (2) bolts that attach the wireframe guard to the vehicle as shown. Perform procedure on both sides of the vehicle. 2. Apply (1) foam rubber strip on the inner side of each leg guard to help against vibration between the leg guard and the vehicle plastics. See fig. 1.

WIRE FRAME GUARD

REMOVE FACTOY BOLTS

INSTALLATION: 1. Position the left lower leg guard in place as shown in the diagram below. Re-install the (2) retained factory bolts at the forward mounts. Install (3) self-tapping screws at the rear (3) mounting points into the plastics of the vehicle. Repeat the procedure on the right side of the vehicle. NOTE: The right side lower leg guard only requires (2) self-tapping screws. FIG. 1 FASTEN SELF-TAPPING SCREWS INTO VEHICLE PLASTICS

RE-INSTALL FACTORY BOLTS

APPLY FOAM RUBBER STRIP ON INSIDE OF THIS LEG

MAINTENANCE: Periodically check to see that the leg guards are properly installed. Re-torque mounting bolts when necessary. Do not operate the vehicle if any bolts or fasteners are loose or missing. CUSTOMER SERVICE: For further information, please contact Pro Armor at 1-951-343-9270. K082044

K082044_TeryxLowerLegGuards_Instructions  

3 SELF-TAPPING SCREW 5 4 FOAM RUBBER STRIP 2 PART DESCRIPTION QTY PART DESCRIPTION QTY PARTS LIST: REMOVE FACTOY BOLTS Please read these ins...

Advertisement