Page 1

KAWASAKI KFX450R PRO RACE GRAB BAR (K081059) INSTALLATION INSTRUCTIONS

Please read these instructions carefully before installation to avoid injury to yourself or damage to your ATV. PARTS LIST: ITEM #

DESCRIPTION

QTY

1

1

PRO RACE GRAB BAR 2

M8 FLAT WASHER

2

PREPARATION:

1. Remove (4) OE sub-frame mounts from the rear of your ATV retaining the mounting hardware. Also remove and retain (2) OE rear fender support brackets. 2. Disconnect the rear brake light assembly and remove the stock grab bar. 3. Un-install the rear brake light assembly from the stock grab bar retaining the OE hardware. INSTALLATION:

1. Using the retained mounting hardware re-install the rear brake light assembly to the Pro Armor Pro Race Grab bar. 2. Re-connect the rear brake light assembly. 3. Align the mounting points of the grab bar to those of the ATV’s frame. 4. Install (2) stock bolts removed in Preparation step 1 at the rear most mounting points on either side. Do not fully tighten. 5. Place (1) item #2 washer over the lower forward mounting point on each side of your ATV’s frame. This will be used as a spacer between the ATV frame and the fender brackets. 6. Loosely re-install the sub-frame mounting brackets using the retained OE hardware, positioning the grab bar between the frame of the ATV and the sub frame mounts. 7. Secure the grab bar in place by tightening down on the mounting bolts. MAINTENANCE:

Periodically check to see that all bolts are tightened down. Do not operate the vehicle if the grab bar or any of the mounting bolts are loose or missing. CUSTOMER SERVICE:

For further information, please contact Pro Armor at 951-270-0559. K081059

K081059_KFX450ProRaceGrabBar_Instructions  

Periodically check to see that all bolts are tightened down. Do not operate the vehicle if the grab bar or any of the mounting bolts are loo...

Advertisement