Page 1

PRO VAULT HANDLEBAR MOUNT (A001210) INSTALLATION INSTRUCTIONS Please read these instructions before installation to avoid injury to yourself or damage to your ATV. INSTALLATION:

INCLUDED IN KIT

INSTALLED MOUNT WITH iPOD HOLDER (NOT INCLUDED)

1. Remove and retain the (2) hex head screws included with your handlebar mount kit. 2. Position the 2 sections of the mount so that it wraps around the handlebar. Position the main section of the mount so that the iPod holder slot faces up and towards the rider of the ATV. Align the half arc section of the mount with the main section so that the handlebar is in between the two. 3. Re-install the (2) hex head screws into the mounting holes and tighten them. 4. Slide the backing of your iPod holder onto the iPod holder slot of the handlebar mount. 5. Using the tightening screw located on the upper rear of the mount, fix the iPod holder in place. APPLICATIONS:

A001210 Handlebar Mount is compatible with the following ProVault iPod holders: A001200 (Billet 30GB ProVault), A001201 (Billet 1st Gen. Nano ProVault), A001202 (Billet 60GB/80GB ProVault) and the A001203 (Billet 2nd Gen. Nano Pro Vault). NOTE:

The 30, 60 and 80 GB iPods should not be used in off-road environments and should not be exposed to heavy vibration that may damage the iPod. For off-road applications, the iPod Nanos are suitable for use. When using your iPod, never have the volume to where you are not able to hear the surrounding noises.


CUSTOMER SERVICE:

For further information, please call Pro Armor at 951-270-0559.

A001210

A001210_iPodHandlebarMount_Instructions  

The 30, 60 and 80 GB iPods should not be used in off-road environments and should not be exposed to heavy vibration that may damage the iPod...