Page 113

Bubbles I N F L AT I O N I N S T R U C T I O N S & H E L I U M G U I D E L I N E S Air Bubble • Inflate with a latex balloon regulator or hand

• • •

pump immediately upon opening. All 10 Air Bubbles must be inflated upon opening the pack. Air inflate using only nitrogen or compressed air. NEVER use helium to inflate an Air Bubble. Inflate until all wrinkles completely disappear from seam, which may require approximately 3.5 to 3.8 psi. Heat seal Air Bubble after inflating. Caution: If the sealer is too hot the plastic will burn, if it is too cold, the air will escape. Smooth and heat seal as high as possible on the neck without overheating the curve on the Bubble.

Tips • Once the package is opened, Bubbles must be inflated immediately •

or they’ll dry out. Discard the moisture pack after inflation. Do NOT use a foil (auto shut-off) regulator to inflate Single Bubbles, the outer bubbles of Double Bubbles, or Deco Bubbles; if you do, the foil regulator will shut off too soon and your Bubble will look more like a foil balloon. ONLY use latex regulators or Bubble inflators on these Bubbles, and keep inflating until the wrinkles and bumps are gone.

Deco Bubble • Inflate with a latex balloon regulator immediately upon opening. When

air inflating, use nitrogen or compressed air. Do not use an automatic shut-off regulator or regular air inflator; they do not have enough power to inflate a Qualatex® Bubble Balloon® wrinkle-free. Hand pumps or other electric air inflators can be used. When inflating Deco Bubbles, NEVER leave ANY wrinkles on the seam. Although the balloon will seem tight, continue inflating and stop just as the wrinkles disappear, leaving a perfectly smooth seam.

Tying Deco Bubbles 1. Tightly grip the neck and twist several times. 2. Wrap a ribbon, 160Q, or 260Q around the neck and tie a permanent knot. Tying the knot extremely tight will ensure a long-lasting Deco Bubble.

Helium Guidelines Over inflating or under inflating Bubbles can decrease float times, so follow package instructions to inflate properly and achieve the best float times. Actual flying times will also depend on temperature and atmospheric conditions. Deco Bubble float times will vary if other types of balloons are placed inside. The average number of Bubble balloons inflated with a 3.6m3 tanks is 90 - 130 for 22" Single Bubbles and 85 - 105 for 24" Double Bubbles. The average number of Deco Bubble balloons inflated with a 3.6m3 tanks is dependant on the number and size of latex balloons used inside the Deco Bubble.

Bubble Inflation

Display

Digital Inflator 10ft Extension Hose #48965 The Digital Inflator 10ft Extension hose snaps onto the back of the Dual Split-Second Sizer or Duplicator 2 and allows the user to inflate up to 10 feet away. Choose from five different Snap-On outlets! See page 214 for a selection of Snap-On outlets. Benefits: • Inflate balloons up to 10 feet away from Dual Sizer or Duplicator 2 • Easily change Snap-On outlets • Automatically inflate Bubbles and Deco Bubbles with Snap-On Bubble Outlet

Bubbles Cardboard Display (empty) #26161 Size of the Bubbles Box (when set up) 61cm x 38cm x 38cm

S T R E TC HY P L A S T I C B A L LO O N S

The Bubble Inflator #39193 Bubble inflator automatically inflates Bubbles and Deco Bubbles to the perfect pressure and size with wrinkle-free seams.

109

2017 PEL Qualatex Everyday Catalog  
2017 PEL Qualatex Everyday Catalog